W
Shut off the power at the fuse box or circuit breaker. If
necessary, remove old fixture, including mounting
on and
check that all parts are included as shown in the
box
F3) to the nipple (J) of the fixture body
Pass the wires carefully through each rod as you
ods (F) and thread the
ease remove the nipple
by
the hanger ball (E) slips
Align the notch
in the hanger ball (E) to the tab on the mounting plate
At this point, connect the electrical wires as shown in
, making sure that all wire connectors are
If your outlet has a ground wire (green or
the
to it. Otherwise,
directly
the
. After wires are connected,
late (A) and
in accordance
(DO NOT EXCEED THE
NE PAS DEPASSER LA
Your installation is now complete. Return power to the
Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
FIXTURE
HOUSE
FIXTURE
HOUSE
FIXTURE
HOUSE
H
F3
F2
C
D
INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
A R N I NG ! S H U T P O W E R O F F AT F U S E O R CI R C U IT B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARATION (Fig. 1)
1.
hardware.
2. Carefully remove the fixture from the cart
Fig. 1
-Mounting Plate
-Ground screw
A
-Mounting Screw*2
B
illustration.
ASSEMBLING THE FIXTURE WITH BALL SWIVEL (Fig. 2)
3. Attach the mounting plate (A) to the junction
E
F1
using mounting screws (B) (Size: #8-32N*L0.5”).
4. Determine the desired hanging height and thread rods
(F1, F2, and
(G).
assemble.
5. Place the canopy (C) over r
Rod 1 (F1)
2 (F2)
1 (F3)
hanger ball (E) to rods (F). Pl
if installing with one 6” rod only.
6. Install the fixture body into the mounting plate (A)
tilting at a slight angle so that
into the mounting plate (A) as shown.
(A) to prevent the fixture from turning.
CONNECTING THE WIRES (Fig. 3)
J
G
7.
figure 3
secured.
bare copper), connect the ground wires from
hanger ball and mounting plate
connect the ground wire from the hanger ball
to the mounting plate ground wire and secure with
wire connectors provided
tuck them carefully into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig. 1)
8. Align the canopy (C) over the mounting p
secure with screws (D).
9.
Install the light bulb(s) (not included)
with the fixture’s specifications.
MAXIMUM WATTAGE RATING!) (
PUISSANCE NOMINALE MAXIMALE!).
Fig. 3
WIRES
Black or
Smooth
WIRES
White or
Ribbed
WIRES
Bare
Copper
(Ground)
junction box and test the fixture.
Note:
identical to the fixture purchased.
Page: 1/2
WIRES
Black
(Hot)
WIRES
White
(Neutral)
WIRES
Green
(Ground)
C
A
F1. ROD 12"*1
F2. ROD 12"*2
F3. ROD 6"*1
A. Mounting Plate*1
*1
D C
A
Fig.2
a. Hardware Bag:
b. Hardware Bag:
Page: 2/2
C. Canopy*1
D. Screw*2
E. Hanger Ball
F1
F2
B
E
F1
D
E
F3
Loading...