1
1
CERTIFICATION: UL DAMP
INSTALLATION INSTRUCTIONS
IMPORTANT
Before assembling, please make sure that you carefully read through
these instruction sheets. Consider having your fixture installed by a
qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
WHAT WE PROVIDE
Mounting Hardware
•
• Crossbar Plate
• 4 x Glass shades
• 4 x 40W G9 Bulb
PREPARE FIXTURE
If there is an existing fixture remove it.
Expose the supply wire from the outlet box.
APPLICATION
Wall Fixture
WHAT YOU NEED
Screwdriver
•
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: UL DAMP
3
MOUNT CROSSBAR PLATE
Gently pull the supply wires out of the j-box.
Mount the crossbar to the J-box with the supplied
screws.
MAKE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply
wire to the black fixture wire. Secure with the supplied
wire nuts. Connect the white supply wire to the white
fixture wire. Secure with the supplied wire nuts. Either
wrap the green wire around one of the protruding screws
or connect it to the supply ground wire. Secure all wire
with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT FIXTURE TO THE CROSSBAR PLATE
Position the fixture plate over the crossbar plate.
Align the holes at the top the plates.
Secure with the supplied screws.
3
CERTIFICATION: UL DAMP
5
6
SECURE THE GLASS SHADES AND
THE BULBS
Hold the glass shades at a slight angle to the fixture and
fit over the socket spring.
Do not insert shades vertically as the glass may crack.
Insert the supplied bulbs. MAXIMUM WATTAGE 40W.
DO NOT EXCEED THE WATTAGE AS STATED
ON THE WARNING LABEL AND IN THE INSTRUCTION
SHEETS
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
INSERT
NEW ACCESS LIGHTING FIXTURE
Please ensure that the fitting is cool and
switched off before replacing the bulb.
CAUTION
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
Loading...