LIGHTING
PLEASE READ AND SAVE FOR FUTURE REFERENCE.
CAUTION
1. Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible shock.
2. All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If
you are unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.
GENERAL
Remove all parts and hardware from the box and make sure that none are missing by referencing the illustrations
provided.
Do NOT tamper with or attempt to repair LED component of fixture.
(Series Included 10W LED/Series Included 14W LED/Series Included 18W LED)
Outdoor Pocket Sconce
1. OUTLET BOX (not included)
2. MOUNTING PLATE (pre-attached)
3. OUTLET BOX SCREWS and
WASHERS (pre-attached to outlet box)
4. BLACK SUPPLY WIRE (not included)
5. SMOOTH (or BLACK) FIXTURE
LEAD WIRE
6. WHITE SUPPLY WIRE (not included)
7. RIBBED (or WHITE) FIXTURE LEAD
WIRE
8. SUPPLY GROUND WIRE (not included)
9. FIXTURE GROUND WIRE
10. WIRE CONNECTORS
11. GROUND SCREW (pre-attached)
12. FIXTURE SCREWS
13. LED FIXTURE
7
13
6
2
1
3
9
12
5
4
8
11
10
12
WARNING: To prevent moisture from entering the outlet box and causing a shock,
After Completing installation use clear caulking to outline the outside of the fixture's
backplate where it meets the wall, leaving a space at the bottom to allow moisture
a means of escape.
Backplate
Caulk
Caulking
Lighting Limited Warranty
We warrant all our Products to be free from defects in material and workmanship subject to certain conditions and exclusions,
for period of three years from the date the Product was shipped to the original end use purchaser.
We will warranty our product only if it is sold through an authorized our dealer.
We will, at its discretion, repair, replace or make appropriate adjustment where inspection discloses any defects
occurring in normal usage within the applicable time period above, subject to the following conditions and exclusions.The
following costs, expenses and damages are not covered by the provisions of this limited warranty: (1.) labor costs
including, but not limited to, costs associated with the removal and reinstallation of Product; (2.) shipping and freight
expenses required to return Product
CARE & CLEANING: Initial care for finishes requires periodic cleaning with a soft cloth, dampened with water. A mild
non-abrasive soap may be used along with a soft cloth and water if the fixture is very dirty. Particular care should be taken
to avoid abrasive materials and strong cleaning agents as they will quickly destroy the protective coatings and subject the
finish to oxidation and discoloration.
Loading...