1
M800183A
Valve handle & quick connect kit for
HBHR280GX, HBHR350GX
Instructions for Assembly
Valve Handle & Quick Connect Kit
WARNING
Before installing kit or operating unit, please read instructions in owner’s manual and review warnings.
Failure to read the manual before installing components could result in serious injury or damage to the
hydraulic power pack.
Any Questions, Comments, Problems or Parts Orders
Call Brave Product Support 1-800-350-8739
2
Installation Instructions
Kit Contents
REF
ITEM #
DESCRIPTION
QTY
-
1159418
SINGLE SPOOL MONO-BLOCK 20 GPM (Already installed)
1
A
Valve Handle and associated parts
1
B
1014003
#08 Male ORB X 1/2 Male NPT
2
C
1085800
F.bir 12 NPT - 1/2" NPT Coupler
1
D
1085801
M.bir 12 NPT - 1/2" NPT Tip
1
E
1081058
1/2 BODY DUST PLUG
1
F
1081070
1/2 DUST CAP
1
A E F C D
B
B
3
Installation Instructions
Step 1 – Handle to Control Valve
• Locate valve on unit.
• Slide clevis onto valve body, insert pins, and secure with supplied
cotter pins.
• Slide control valve handle into the clevis slots on control valve.
• Align holes in handle with clevis holes.
• Insert the supplied pins through holes and secure with supplied cotter
pins.
Tools Needed
• Pliers
Clevis
Valve handle
4
Installation Instructions
Step 2 – Install fittings
• Install fittings in order shown to ports as indicated by A and B.
• Thread O-ring side of NPT x ORB fittings into the valve ports A and
B finger tight.
• Torque fittings to valve at 37-46 ft.-lb.
• CAUTION: Never back off an installed pipe fitting to achieve proper
alignment. Loosening installed pipe fittings will corrupt the seal and
contribute to leakage and failure.
• Slip rubber straps over NPT x ORB fittings.
• Apply thread sealant and screw finger-tight (2) NPT x quick
disconnect fittings onto the fittings installed into valve A and B ports.
Which fitting is attached to which port is up to the customer. Please
refer to owner’s manual to determine direction of flow and desired
configuration of quick disconnect fittings.
• Hold NPT x ORB fitting and wrench-tighten the quick disconnect
fitting to 1.5-3.0 Turns Past Finger Tight position. Properly
assembled fittings total thread engagement should be 3.5-6 turns.
• Press plug/cap into place over quick disconnect fittings.
Tools Needed
• Adjustable wrench
• 7/8 Deep Socket
• Torque Wrench
• Ratchet
1/2 DUST CAP
½ NPT x Male Quick Connect
#08 Male ORB X 1/2 Male NPT
1/2 DUST PLUG
½ NPT x Female Quick Connect
#08 Male ORB X 1/2 Male NPT
5
This page has intentionally been left blank.
6
20195 S. Diamond Lake Rd, Ste 100
Rogers, MN 55374
1-800-350-8739
Loading...