Page 1
Multiquick® 7
Leporello, 148x210 mm, 12 pages, 1/1c = black
Cordless Hand Processor
MR 740 cc
Page 2
2
1
1
2
3
4
5 5
6
7
10
8
9
a
2
b
c
Page 3
A
2
1
2
1
10
a
1
2
3
B
b
c
d
10
e
4
5
6 7
8 9
1
f
4 5 6
2
3
7
C
1cm
3
250 g
30
1cm
200 g
45
200 g
15 15
30 g
15
30 250 g 5 350 g
15
+
400 g 150 g + 700 ml
15 60 15
+
Page 4
4
Page 5
5
Page 6
a
b
2
1
c
d
2
1
6
3
e
h
k
1
2
f
2
1
i
1
2
l
4
g
3
j
2
m
3
1
2
1
Page 7
7
Page 8
8
Page 9
English
Our products are engineered to meet the highest
standards of quality, functionality and design. We
hope that you thoroughly enjoy your new Braun
appliance.
Please read the use instructions carefully and
completely before using the appliance.
Caution
•
• High risk of injury by switching on the appliance
unintentionally. As this is a rechargeable
appliance, it is ready for use anytime (when
charged).
• Do not expose the appliance to direct sunlight.
• When the blades are blocked remove motor part
from blender shaft, before removing the food/
blockage.
• Before cleaning, remove blender shaft from motor
part.
• The appliance is constructed to process normal
household quantities.
• This appliance is provided with a special cord set
with an integrated Safety Extra Low Voltage
power supply. Do not exchange or manipulate any
part of it. Otherwise there is risk of electric shock.
• Only use the appliance with the charging unit
supplied.
• The charging unit can remain permanently
connected to the mains.
• Protect the motor part, the charging unit and
special cord set against humidity. Motor part and
power supply of special cord set must no longer
be used after they have been immersed in water.
• This appliance is not intended for use by children
or persons with reduced physical or mental
capabilities, unless they are given supervision by
a person responsible for their safety. In general,
we recommend that you keep the appliance out of
reach of children. Children should be supervised
to ensure that they do not play with the appliance.
• Before use, make sure that charging unit and
special cord set are not damaged. Braun electric
appliances meet applicable safety standards.
• Repairs or the replacement of the mains cord
must only be done by authorised service
personnel.
• Faulty, unqualified repair work may cause
considerable hazards to the user.
The blades are very sharp! Handle blades
with utmost care in order to prevent
injuries.
Description
1 Pilot light
2 Switch release button
3 On switch
4 Motor part
5 Push buttons for releasing the accessories
6 Blender shaft
7 Beaker
8 Charging unit (incl. cord storage)
9 Special cord set
10 Chopper attachment
(a) Gear lid
(b) Blade
(c) Chopper bowl
(d) Anti-slip base/lid
(e) Ice blade
(f) Ice crusher insert
Charging
The ideal temperature range for charging is between
15 °C and 35 °C.
Make sure that the charging unit (8) is located on a
level surface. Connect the charging unit to the mains
via the special cord set.
For charging, place the complete handblender in the
charging unit (8) – (motor part alone also possible).
The green pilot light confirms that the appliance is
properly inserted in the charging unit and that it is
being charged.
• Full charge: ca. 2 hours
• Fully charged: the pilot light flashes with longer
intervals
• Operation time is ca. 20 minutes (depending on
way of usage)
After every usage, place the appliance back onto
the charging unit for recharging. This will make sure
that it is always ready for use with optimum charging
conditions. You may as well store the appliance on
the charging unit. Even if not in use for a long period
of time, the lithium ion batteries implemented maintain their charging level to a large extent.
The batteries are protected against deep discharge.
A completely discharged appliance has to be
charged for at least ca. 15 minutes before it can be
used for an application (e.g. soup).
Pilot Light
Appliance in
charging unit
(connected to the
mains)
Green flashing Battery is charging
Green flashing
(in longer intervals)
Charging or operation
conditions
Battery is fully charged
9
Page 10
Switch release
button (2) pressed
down
Green Battery is fully charged
Red/green flashing Charge sufficient for at
Charging or operation
conditions
least one usage
Auto Off
For safety reasons the appliance turns off after
4 minutes of permanent usage. The appliance can
be turned directly on again.
Red Battery is discharged
Red Overheating protection
active (go to Safety
features A Overheat
protection)
Safety features
Switching on the appliance / Switch lock
The appliance has a switch lock. To safely switch it
on, follow these points:
1 First press the switch release button (2) with your
thumb and hold.
2 Then press the On switch (3). During operation,
you can stop pressing the switch release button.
• If the On switch (3) is not pressed within
5 seconds, the appliance cannot be switched
on. The pilot light goes off.
• In order to switch the appliance on, start again
with step 1.
Overheat protection
When the overheat protection feature is active,
the appliance turns off and the pilot light shines
permanently red.
Reason Trouble shooting
Blade is blocked
Appliance is
overheated
1. Remove motor part
2. Remove the food/
blockage
3. Place the motor part
into the charging unit
(connected to the mains)
for at least 1 second
4. Processing can be
continued
Follow points 1.-4.
If the pilot light still shines
red when switching on the
appliance, place the motor
part back into the charging
unit and let it cool down
for ca. 1 hour. During this
time, the pilot light flashes
green.
Using your handblender
The handblender is perfectly suited for preparing
dips, sauces, soups, mayonnaise and baby food as
well as for mixing drinks and milkshakes.
a) Remove knife protection at the bottom of the
blender shaft by removing the adhesive tape.
Insert the motor part (4) into the blender shaft (6)
until it locks.
b) Introduce the handblender vertically into the
vessel, keep the switch release (2) pressed down,
then press the On switch (3).
c) To remove the blender shaft from the motor part,
press push buttons (5).
When operating the handblender in hot liquids do
not immerse the blender shaft into – or remove it
from the liquid while the appliance is switched on.
Recipe example:
Mayonnaise
200–250 ml oil,
1 egg (yolk and white),
1 tbsp. lemon juice or vinegar,
salt and pepper to taste
Put all ingredients into the beaker according to the
a.m. order. Introduce the handblender to the base of
the beaker. After switching on, keep the handblender
in this position until the oil emulsifies. Then, without
switching off, slowly move it up and down until the
mayonnaise is well combined.
Using your chopper attachment
The chopper is perfectly suited for chopping meat,
cheese, onions, herbs, garlic, carrots, walnuts,
almonds, prunes etc.
N.B.: Do not chop extremely hard food, such as
nutmeg, coffee beans and grains.
Before chopping ...
• pre-cut meat, cheese, onions, garlic, carrots, chilis
(see processing guide S. 5)
• remove stalks from herbs, un-shell nuts
• remove bones, tendons and gristle from meet.
10
Page 11
Chopping
(see picture section A)
1. Carefully remove the plastic cover from the blade
(10b). Caution: the blade is very sharp! Always
hold it by the upper plastic part.
Press the blade onto the centre pin of the chopper
jug (10c) until it locks. Always place the chopper
jug on the anti-slip base (10d).
2. Place the food in the chopper jug.
3. Put the gear lid (10a) on the chopper jug.
4. Insert the motor part into the gear lid until it locks.
5. Keep the switch release button (2) pressed down
and press the ON switch (3) to operate the
chopper. During processing, hold the motor part
with one hand and the chopper jug with the other.
When chopping hard foods, press down the motor
part.
6. After use, press buttons to remove the motor part.
7. Then remove the gear lid.
8. Carefully take out the blade.
9. Remove the processed food from the chopper
jug. The anti-slip base also serves as an airtight lid
for the chopper jug.
Shakes, drinks, purées
For purées, when very fine results are preferred, you
may also use the handblender shaft in the jug.
Cleaning
Before cleaning remove the motor part. Do not
immerse the motor part (4) and charging unit (8) in
water nor hold them under running water. These
parts can only be cleaned with a damp cloth.
The chopper gear box (10a) is not dishwasher-proof.
All other parts are dishwasher-proof.
When processing foods with colour (e.g. carrots),
the plastic parts of the appliance may become
discoloured. Wipe these parts with vegetable oil
before cleaning them.
For electric specifications, please see printing on the
special cord set. The special cord set automatically
adapts to any worldwide AC voltage.
Subject to change without notice.
This appliance contains Li-Ion rechargeable
batteries. Please do not dispose of the
product in the household waste at the end
of its useful life. Disposal can take place at
a Braun Service Centre or at appropriate
collection points provided in your country.
Light dough (pancake batter)
First pour liquids into the jug, then add flour and
finally eggs.
Crushed ice
(see picture section B)
1. Place the ice crusher insert (10f) into the jug.
Ensure it fits properly.
2. Place the shaft of the ice blade (10e) into the
centre hole of the ice crusher insert and press it
down.
3. Fill ice cubes into the ice crusher insert.
4. Fit the gear lid on the jug.
5. Insert the motor part into the gear lid until it locks.
6. Keep the switch release button (2) pressed down
and press the ON switch (3) to operate the
chopper. After use, press buttons to remove the
motor part. Then remove gear lid, ice blade and
ice crusher insert.
7. Remove the crushed ice or simply fill your drink
into the jug for serving at the table.
Alternative: First mix fruits in the jug with the
chopper blade (10b), filling it up to 0.5 litres
maximum. Remove the blade and place the ice
crusher insert into the jug in order to crush ice
directly into the pureed fruits.
11
Page 12
99676583/VIII-10
China/GB
Loading...