Bramec Corporation 1006 DATA SHEET

SAFETY DATA SHEET
Date Prepared : 05/20/2015
MSDS No : 1006
1. PRODUCT AND COMPANY IDENTIFICATION
PRODUCT DESCRIPTION: Bramec Cork Tape PRODUCT CODE: 1006
DISTRIBUTOR: 24 HR. EMERGENCY TELEPHONE NUMBERS
Bramec Corp. 403 Highway 105 North Sioux City,
Customer Service: 800-843-9974 E-Mail: bramecsales@bramec.com
2. HAZARDS IDENTIFICATION
GHS LABEL
No labeling applicable
SD 57049
CHEMTREC (US Tr ansportation) : (800) 424-9300
Page 1 of 4
EMERGENCY OVERVIEW
PHYSICAL APPEARANCE: Black mastic.
IMMEDIATE CONCERNS: May cause skin or eye irritation after repeated or prolonged contact.
POTENTIAL HEALTH EFFECTS
EYES: Contact may cause eye irritation.
SKIN: Prolonged or repeated contact may cause skin irritation. Contact with heated product may result in burns.
SKIN ABSORPTION: None Expected.
INGESTION: Not a likely route of entry.
INHALATION: Not a likely route of entry.
COMMENTS: The Health hazards of this product should be low under normal industrial and commercial use.
3. COMPOSITION / INFORMATION ON INGREDIENTS
Chemical Name Wt.% CAS
Cellulose ~ 2.82 9004-34-6
Silica, Crystalline < 1 14808-60-7
4. FIRST AID MEASURES
EYES: Immediately flush eyes with plenty of water. Get medical attention, if irritation persists.
SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
INGESTION: Normally not needed. If large quantities are ingested, seek medical advice.
INHALATION: No specific treatment is necessary since this material is not in an inhalable form.
SIGNS AND SYMPTOMS OF OVEREXPOSURE
Page 2 of 4
SAFETY DATA SHEET
Date Prepared : 05/20/2015
MSDS No : 1006
EYES: May cause skin or eye irritation after repeated or prolonged contact.
SKIN: Substance may cause slight skin irritation.
SKIN ABSORPTION: None Expected.
5. FIRE FIGHTING MEASURES
EXTINGUISHING MEDIA: Dry chemical, carbon dioxide or foam. Treat as a petroleum fire.
HAZARDOUS COMBUSTION PRODUCTS: CO, CO2, and hydrocarbons
EXPLOSION HAZARDS: None Expected.
FIRE FIGHTING PROCEDURES: As in any fire, wear self-contained breathing apparatus operated in pressure-demand mode,
(NIOSH approved or equivalent) and full protective gear.
HAZARDOUS DECOMPOSITION PRODUCTS: If heated to decomposition, may emit toxic and/or irritating fumes.
6. ACCIDENTAL RELEASE MEASURES
SMALL SPILL: Pick up clean material and place into storage container for future use. Dispose of waste material in accordance
with all local, state/provincial, and national requirements.
LARGE SPILL: Use same methods described for small spills.
7. HANDLING AND STORAGE
HANDLING: Use of proper hygiene practices in the workplace is recommended.
STORAGE: Keep container closed and in a well-ventilated place. Keep container dry.
STORAGE TEMPERATURE: Store in a cool place below ( 120 ) F (49 ) C.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
EXPOSURE GUIDELINES
OSHA HAZARDOUS COMPONENTS (29 CFR1910.1200)
EXPOSURE LIMITS
OSHA PEL ACGIH TLV Supplier OEL
Chemical Name ppm mg/m
3
ppm mg/m
3
ppm mg/m
Cellulose TWA 15T 5R 10
3
Silica, Crystalline
TWA 250mpp 10 0.025 NL NL
STEL NL NL
ENGINEERING CONTROLS: A system of local and/or general exhaust should be adequate under normal conditions.
PERSONAL PROTECTIVE EQUIPMENT
EYES AND FACE: Where contact with this material is possible, eye protection is recommended. May cause skin or eye
irritation after repeated or prolonged contact.
Loading...
+ 2 hidden pages