Bradley Smoker TDB3104, WF3204 User Manual
Installation
Instructions
TDB3104
Terreon®54" Semi-Circular Deep
Bowl Washfountain with
Air Metering Valve
WF3204
Terreon®Extra Height 54" SemiCircular Classic Washfountain
with 9" Deep Bowl and
Air Metering Valve
215-1470 Rev. H; EN 06-915
© 2007 Bradley Corporation
Page 1 of 29 2/8/07
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY FAX 262-251-5817
http://www.bradleycorp.com
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . . . 2
Model TDB3104 Washfountain Dimensions . . . . 3
Model WF3204 Washfountain Dimensions . . . . . .4
Washfountain Rough-Ins . . . . . . . . . . . . . . . . . . 5-7
Drain Installation . . . . . . . . . . . . . . . . . . . . . . . . . .8
Bowl/Pedestal Mounting and Assembly . . . . . . . .9
Drain Spud Installation . . . . . . . . . . . . . . . . . . . . .10
Air Valve Installation (A/O drains) . . . . . . . . .11-12
Air Valve Installation (B/H drains) . . . . . . . . .13-14
Valve and Tubing Connections . . . . . . . . . . . .15-17
Vernatherm Adjustment Procedure . . . . . . . . . . . .18
Terreon® Cleaning/Maintenance . . . . . . . . . . . . .19
Gel-Coated Fiberglass Cleaning/Maintenance . . .19
Stainless Steel Cleaning/Maintenance . . . . . . . . .20
Soap Dispensing Valve Repair Parts . . . . . . . . . .21
Soap Recommendations and Maintenance . . . . . .23
Sprayhead Troubleshooting/Repair Parts . . . . . . 24
Actuator Module Assembly Components . . . . . .25
Metering Air Valve Maintenance . . . . . . . . . .25-27
Vernatherm™ Mixing Valve Maintenance . . .28-29
Cleaning the Strainer . . . . . . . . . . . . . . . . . . . .28-29
TDB3104 with Push Button Air Valve
WF3204 with Push Button Air Valve
TDB3104 Juvenile Height with
Push Button Air Valve
TDB3104 TAS Height with
Push Button Air Valve
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
TDB3104, WF3204 Installation Instructions
Bradley Corporation • 215-1470 Rev. H; EN 06-915
2 2/8/07
Pre-Installation Information
IMPORTANT: Read this entire installation manual to ensure proper installation.
IMPORTANT: Flush all the water supply lines before making connections.
IMPORTANT: Main water supply to the unit should be ON at all times.
IMPORTANT: This installation manual and parts list should be filed by the owner’s
maintenance department.
Cylindrical air valve
The air valve pushbutton allows each user to activate an air metering valve (starting the flow of
water) by pushing and releasing the pushbutton. The air metering valve is factory-preset to run for 10
seconds and can be adjusted to run from 5-60 seconds.
Supplies required for installation:
• (4) lag bolts, screws or other fasteners to anchor washfountain pedestal
• 1" hot and cold water supply lines and fittings (refer to rough-ins on pages 6-7)
• Reducing fittings and 1/2" nom. copper tubing supply lines for types with supplies from above
• Standard P-trap (refer to rough-ins on pages 6-8) (vented trap supplied by Bradley when
required)
• 2" drain lines and fittings (refer to rough-ins on pages 6-7)
• Teflon tape or pipe dope
• 1-1/2" vent or tie pipe on fixtures vented through washfountain column (see page 8 for lengths
required)
Terreon® Semi-circular Washfountain Warranty
Product warranties may be found under “Product Information” on our website at www.bradleycorp.com
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
32/8/07
Semi-Circular Washfountain Dimensions
Optional equipment may not comply with all ADA
dimensional guidelines
Model TDB3104
54" Semi-circular - side view
Figure 1a
40"
(1016)
32-1/4"
(819)
5-1/4"
(133)
TOWEL DISPENSER
MOUNTING HOLES
22-3/4"
(577)
ADJUST TO
6"
(152)
64" (1626) WITH SOAP
55-1/2" (1410) WITHOUT SOAP
55-3/4"
(1416)
47-1/4"
(1200)
43-3/4"
(1111)
34"
(864)
27"
(686)
23-1/2"
(597)
15"
(381
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
TDB3104, WF3204 Installation Instructions
Bradley Corporation • 215-1470 Rev. H; EN 06-915
4 2/8/07
Semi-Circular Washfountain Dimensions (juvenile height)
Model TDB3104
54" Semi-circular - side view
Figure 1b
Figure 1c
Optional equipment may not comply with all ADA
dimensional guidelines
32-1/4"
(819)
5-1/4"
(133)
TOWEL DISPENSER
MOUNTING HOLES
22-3/4"
(577)
ADJUST TO
6"
(152)
*59-1/2" (1511) WITH SOAP
*51" (1295) WITHOUT SOAP
*51-1/4"
(1301)
*42-5/8"
(1084)
*34"
(864)
15"
(381
12-1/2"
(318)
*3-1/2"
(89)
17-1/2"
(444)
*39-1/8"
(994)
*30"
(762)
*23-1/2"
(597)
* ADD 2" (51) FOR TAS HEIGHT UNIT
54" Semi-circular - rear view
pedestal access
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
52/8/07
Semi-Circular Washfountain Dimensions
Model WF3204 is not ADA compliant
Model WF3204
54" Semi-circular - side view
Figure 1d
41"
(1041)
32-1/4"
22-3/4"
(577)
5-1/4"
(133)
(819)
6"
(152)
ADJUST TO
TOWEL DISPENSER
MOUNTING HOLES
43-3/4"
(1111)
34"
(864)
64" (1626) WITH SOAP
55-1/2" (1410) WITHOUT SOAP
55-3/4"
(1416)
47-1/4"
(1200)
15"
(381
23-1/2"
(597)
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
TDB3104, WF3204 Installation Instructions
Bradley Corporation • 215-1470 Rev. H; EN 06-915
6 2/8/07
Rough-In Specifications
NOTE: Supply lines for one to two
washfountains should be 1”; for three
washfountains, 1-1/4”. For more than
three washfountains, pipe sizes should
be increased proportionately.
Figure 2a
Type A Drain
- Supplies from below or through wall
- Vent from below or through wall
off-drain
Figure 2b
Type B Drain
- Supplies from above
- Vent through ceiling off trap inside
pedestal
NOTE: Supply lines for one to two
washfountains should be 1”; for three
washfountains, 1-1/4”. For more than
three washfountains, pipe sizes should
be increased proportionately.
(mm)
(mm)
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
72/8/07
Rough-In Specifications continued . . .
NOTE: Supply lines for one to two
washfountains should be 1”; for
three washfountains, 1-1/4”. For
more than three washfountains,
pipe sizes should be increased
proportionately.
Figure 2c
Figure 2d
NOTE: Supply lines for one to two
washfountains should be 1”; for
three washfountains, 1-1/4”. For
more than three washfountains,
pipe sizes should be increased
proportionately.
Type H Drain
- Supplies from below or through wall
- Vented through ceiling off trap
inside pedestal
Type O Drain
- Supplies from above
- Vented from below or through wall
off drain
(mm)
(mm)
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
TDB3104, WF3204 Installation Instructions
Bradley Corporation • 215-1470 Rev. H; EN 06-915
8 2/8/07
t
Installation Instructions
Step 1: Installing the drain
1. Rough in supply and drain piping as required for your installation (see pages 6-7 for rough-ins
of the optional installations).
2. Assemble the drain to the dimension shown in Figure 3 for the bowl you are installing.
NOTE: All piping shown in dotted lines to be supplied by installer.
Figure 3
Dim Standard Height Juvenile Height TAS
B 23-3/8" (594mm) 22-1/2" (572mm) 24-1/2" (622mm)
Table 1 — “B” Trap Dimensions
Types B, H
Vent
2" NPT Coupling if Tie
Pipe is not required
(Supplied by Installer)
or
Tie Pipe
(Supplied by Installer)
Centerline of
Washfountain
Vented T rap
(111-024)
Centerline of
Washfountain
4"
(102)
T ypes A, O
See rough-ins
on Pages 6-7
for dimensions
not shown
B – See Table 1
Vent
or
Tie Pipe
(Supplied by Installer)
Centerline of
Washfountain
B – See Table 1
4"
(102)
Optional
Tie Pipe Bracke
(S70-082)
B – See Table 1
4"
(102)
T ypes A, O
With Tie Pipe
Bracket Option
Terreon® 54" Semi-circular Washfountain with Cylindrical Air Valve
Installation Instructions TDB3104, WF3204
Bradley Corporation • 215-1470 Rev. H; EN 06-915
92/8/07
Installation Instructions continued . . .
Step 2: Bowl/pedestal mounting and assembly
1. Position pedestal at desired location and mark the position of the (2) pedestal wall mounting
locations and (2) pedestal floor mounting locations (see Figure 5b).
TAS Option:
Place TAS spacer on floor over the mounting holes. Place pedestal on top of the spacer.
2. Secure pedestal to wall and floor with suitable fasteners, 1/2" anchors and 1/2" bolts (supplied by
installer) (see Figure 5b for floor and wall mounting locations).
3. Using two to three people, carefully lift bowl onto pedestal (see Figure 5b).
4. Position bowl so that threaded rods in bowl mate with slotted holes in pedestal (see Figure 5b).
5. Using 1/4" wing nuts and washers, secure bowl to pedestal, three places (see Figure 5b).
CAUTION: BOWL SURFACE IS VERY SMOOTH. APPROXIMATE WEIGHT OF BOWL
IS 146 LBS. (model TDB3104), 136 lbs. (model WF3204) or 101 lbs.
(TDB3104/JUV). HANDLE WITH CARE!
Figure 5b
Figure 5a
DRAIN
TOP VIEW
FRONT VIEW
PLACE HANDS
HERE WHEN
LIFTING BOWL
DRAIN
WALL MOUNTING
LOCATIONS
PLACE HANDS
HERE WHEN
LIFTING BOWL
THREADED ROD
(Secured by 1/4" wing
nut and washer)
PEDESTAL
FLOOR MOUNTING LOCATIONS
Loading...