Page 1
San Jamar SRT/Tear-N-Dry AC Adapter
Installation Instructions
1.) While dispenser remains mounted to the
wall, open cover and remove batteries.
2.) Remove drive module by:
a. Move toggle in back to vertical position.
b. Tilt and pull drive module out -- if angle is
correct, minimal force is needed to pull out.
2b2a
3.) Pull connector with red and black wires
(needle nose pliers work well) out of power
jack behind control panel and remove from
holding tabs (3a). These wires are no longer
used (3b).
4.) a. Thread adapter cord up through opening
as shown.
b. Rout wire through other opening as shown.
c. Plug connector into power jack. Final plug
should resemble photo 4c.
5.) Drop wall plug end through large opening in
bottom of dispenser. The cord should not be
tangled up or wedged between the drive
module and the dispenser shell.
6.) Load paper and close cover.
3
4a
3b
4b
7.) Plug in ac adapter into wall and dispenser is
ready to go!
Questions? Please call customer care at 1-800-248-9826 or visit our website:
www.sanjamar.com
4c
5
100306
Loading...