Bradley Terreon Tri-Fount Multi-Fount Series, Terreon Tri-Fount Multi-Fount MF2939/BIR Installation Instructions Manual

Bradley Multi-Fount™ Series

MF2939/BIR
Terreon

®

Tri-Fount

TM

Wall­Hung Washfountain with
Battery OperatedInfrared
Control

(Standard* & Juvenile
Height)

*ADA compliant when mounted at recommended
heights

Installation
Instructions

Table of Contents

Pre-Installation Information . . . . . . . . . . . . .2-3

Installation Instructions . . . . . . . . . . . . . . . .4-12

Activation Range Adjustment . . . . . . . . . . . . .11

Cleaning and Maintenance . . . . . . . . . . . .13-14

Valve Box Troubleshooting . . . . . . . . . . . . . .15

Battery Troubleshooting . . . . . . . . . . . . . . . . .16

Flow Restrictions . . . . . . . . . . . . . . . . . . . . . .16

215-1372 Rev. F; EN 03-045
© 2003 Bradley Corporation
Page 1 of 16 9-17-2003

P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY FAX [phone]
http://www.bradleycorp.com

IMPORTANT

Read this entire installation manual to
ensure proper installation.

Make sure that water supply is completely
off before beginning installation.

The Tri-Fount™ requires a water flowing
pressure of at least 20 psi but no greater
than 80 psi.

Flush all the water supply lines before
making connections.

Wall anchors used must have a minimum
pull-out rating of 1,000 lbs.

File these instructions with the owner or
maintenance department.

2 Bradley Corporation • 215-1372 Rev. F; EN 03-045

Terreon® Tri-Fount™ Wall-Hung Washfountain with Battery-Operated Infrared Control
MF2939/BIR Installation Instructions

9-17-2003

Pre-Installation Information

Terreon®material

The Tri-Fount™ features Terreon®, a durable solid surface material used on the bowl and pedestal.
Terreon®resists stains, burns and impact, and is repairable with everyday cleaners or fine-grit
abrasives.

Infrared sensor and motor driven valve

Each sprayhead is controlled by a separate motor driven valve, allowing each user to activate a single
flow of water. Each valve uses less than half the maximum amount of hot water allowed by the
ANSI/ASHRAE/IES 90A-1980 Standard.

Barrier-free and ADA compliant

The Terreon Tri-Fount™ with infrared is designed to comply with all ADA guidelines on reaches,
clearances and operation when mounted at standard height dimensions by the installer (see page 4
of this instruction manual for rough-in and mounting dimensions).

Supplies required:

• (6) 3/8" diameter bolts with washers and (6) wall anchors appropriate for your installation

• Hot and cold water supply lines

• Drain trap and waste connection

• (12) AA alkaline batteries

• Pipe sealant and plumber’s putty

Terreon® Tri-Fount™ Wall-Hung Washfountain Warranty

Bradley Corporation warrants to commercial and institutional purchasers only each unit free from
defects in material and workmanship under normal use and service upon the following terms and
conditions.

1. This warranty is limited to replacing or repairing, at our option, transportation charges prepaid
by the purchaser, any Bradley unit or part thereof which our inspection shall show to have
been defective within the limitations of this warranty.

2. The period during which Terreon®Tri-Fount™ components are warranted is as follows:

• Terreon®side panels, bowl, and top cover warranted for 5 years.

• All other Tri-Fount™ components warranted for 1 year.

3. This warranty does not cover installation or any other labor charges and does not apply to any
units which have been damaged by accident, abuse, improper installation or improper
maintenance.

4. The replacement or repair of defective units as stated in this warranty shall constitute the sole
remedy of the purchaser and the sole liability of Bradley Corporation under this warranty.
Bradley Corporation shall not otherwise be liable under any indirect damages caused by
defects in the repair or replacement thereof.

5. This warranty extends only to commercial and institutional purchaser and does not extend to
any others, including consumer customers of commercial institutional purchasers.

6. This warranty is in lieu of all other warranties, expressed or implied, including any implied
warranty of merchants ability or fitness for a particular purpose or otherwise.

3Bradley Corporation • 215-1372 Rev. F; EN 03-045

Terreon® Tri-Fount™ Wall-Hung Washfountain with Battery-Operated Infrared Control

Installation Instructions MF2939/BIR

9-17-2003

Washfountain Components

Parts included with the Wall-Hung Tri-Fount

™

Separate all parts from packaging materials and ensure you have all the parts required for assembly.
If any parts are missing, do not attempt to assemble the Wall-Hung Tri-Fount™ until you obtain all
parts.

4 Bradley Corporation • 215-1372 Rev. F; EN 03-045

Terreon® Tri-Fount™ Wall-Hung Washfountain with Battery-Operated Infrared Control
MF2939/BIR Installation Instructions

9-17-2003

Installation Instructions

Step 1: Rough-in piping and install wall anchors

NOTE: See Figure 1 for piping rough-in dimensions and wall anchor locations.

IMPORTANT: Compliance and conformity to local codes and ordinances is the

responsibility of the installer.

IMPORTANT: Make sure that the water is completely shut off before beginning

installation.

1. Rough-in hot and cold supply lines through the wall.

2. Rough-in a drain waste connection through the wall.

IMPORTANT: Make sure the frame is level when using as a template for drilling

anchor holes.

3. Drill four 1/2" diameter holes in the wall using the frame as a template.

4. Secure the pedestal frame to the wall anchors using four 3/8" diameter bolts and washers
(supplied by installer).

IMPORTANT: Wall anchors need to withstand 1000 lb. pull force.

Figure 1

* Subtract 4" from this dimension for juvenile height model.

1/2" HOT SUPPLY

(STUB OUT

1" FROM WALL)

26-1/2"*

(660)

4-1/4"

23-1/4"*

(591)

1-1/2" NPT WASTE CONNECTION
FOR USE WITH 1-1/2" TUBULAR
P-TRAP – STUB OUT MIN. 2"

10"

(254)
8-1/2"

(216)

(108)

FINISHED FLOOR FINISHED FLOOR

1/2" COLD SUPPLY
(STUB OUT MIN.
1" FROM WALL)

2-1/2"

(64)

27-1/2"*

(699)

25-1/2"*

(648)

28"*

(711)

(508)

20"

10"

(254)

10"

(254)

(6) APPROPRIATE ANCHORS
AND 3/8" BOLTS (SUPPLIED
BY INSTALLERS) TO MOUNT
BOWL TO WALL

OUTLINE OF MOUNTING
PANEL OPENING

10"

(254)

OUTLINE OF
MOUNTING PANEL

18-3/4"*

(476)

5Bradley Corporation • 215-1372 Rev. F; EN 03-045

Terreon® Tri-Fount™ Wall-Hung Washfountain with Battery-Operated Infrared Control

Installation Instructions MF2939/BIR

9-17-2003

Installation Instructions continued . . .

Step 2: Install Vernatherm™ valve

1. Connect the braided hoses and
pipe cross to the Vernatherm™
valve (see Figure 2).

2. Install the two pipe clamps on
the Vernatherm™ assembly
(Figure 2).

3. Install the Vernatherm
assembly by placing the two
pipe clamps on the mounting
studs in the middle of the
pedestal frame (Figure 2).

4. Install the two 1/4-20 nuts and
washers supplied to secure the
pipe clamps to the mounting
studs.

5. Connect the rough-in supply
piping after you have read the
following:

• The stop/check valve must be
used in order to provide proper cross flow checking. No other stops are required. These stops
MUST be fully opened for proper operation of the metering valves.

• The thermostatic mixing valve requires at least 115° F water from the hot water side for proper
operation. As with all lavatories, there will be a delay in obtaining warm water. If the hot water
is too far away from the washfountain, a circulating pump may be required.

FOR SINGLE TEMPERED SUPPLY (OPTIONAL):

Connect the 90° elbow to the 1/2" tempered
supply line as shown in Figure 2a.

Figure 2

Filter Washer

Vernatherm™

Assembly

1/2"

Elbow

Pipe

Clamp

Mounting

Stud

Nut and

Washer

Braided Hoses

Pipe

Cross

Stop/Check

Figure 2a

90° Elbow
To Supply Line

Braided Hoses
From Valve Box

Check/Stop

Cross

Optional Single Tempered Supply