Bradley MG-2/TT Installation Instructions Manual
MG-2/TT
Express® Lavatory
System - MG-Series
with TouchTime®Control
Installation
Instructions
P.O. Box 309, Menomonee Falls, WI 53052-0309
TEL. 1-800-BRADLEY FAX 262-251-5817
http://www.bradleycorp.com
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . . . .2
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-4
Installation Instructions . . . . . . . . . . . . . . . . . . 5-12
Cleaning and Maintenance . . . . . . . . . . . . . . . . . .13
Assembly of Components . . . . . . . . . . . . . . . .14-16
Solenoid Valve Troubleshooting . . . . . . . . . . .17-18
Vernatherm™ Valve Maintenance . . . . . . . . .19-20
Cleaning the Strainer . . . . . . . . . . . . . . . . . . . .19-20
215-1480 Rev. E; EN 06-915
© 2007 Bradley Corporation
Page 1 of 20 2/8/07
IMPORTANT
Read this entire installation manual to ensure proper
installation.
Flush all the water supply lines before making connections.
Wall anchors used must have a minimum pull-out rating of
1,000 lbs.
File these instructions with the owner or maintenance
department.
Product warranties may be found under "Product
Information" on our web site at www.bradleycorp.com.
A
C
O
M
A
D
P
T
L
N
I
A
Express® Lavatory System - MG-Series with TouchTime® Control
MG-2/TT Installation Instructions
2
2/8/07 Bradley Corporation • 215-1480 Rev. E; EN 06-915
Pre-Installation Information
Barrier-free and ADA compliant - standard height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 34" above finished
floor to be compliant with Americans with Disabilities Act (ADA). When mounted at 34" rim height,
the MG-2/TT Express® Lavatory System meets ADA, ANSI and UFAS requirements for barrier-free
clearances, reaches and controls. Always check local codes and ordinances for compliance.
Barrier-free and ADA compliant - juvenile height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 30" above finished
floor to be compliant with Americans with Disabilities Act (ADA) Accessibility Guidelines for
Buildings and Facilities: Building Elements Designed for Children's Use; Final Rule.
Texas Accessibility Standards compliant:
The MG-2/TT Express® Lavatory System meets Texas Accessibility standards (TAS) for barrier-free
clearances, reaches and controls. Always check local codes and ordinances for compliance.
TouchTime®switch and solenoid
Each sprayhead is controlled by a TouchTime®switch, enabling each user to activate a single flow
of water. Each valve uses less than half the maximum of hot water allowed by the
ANSI/ASHRAE/IESNA 90.1-1989 Standard.
Supplies required for installation:
• (8) 3/8" wall anchors, bolts and washers to mount frame and bowl
to wall (minimum pull-out rating of 1,000 lbs.)
• 1/2" NPT hot and cold supply piping and 1-1/2" NPT drain piping
• 1/2" NPT street elbow
• 110 volt electrical outlet for 110/24 VAC plug-in transformer (supplied)
• 240/208-volt or 277-volt electrical outlet for optional electric tankless water heater
3
Express® Lavatory System - MG-Series with TouchTime® Control
Installation Instructions MG-2/TT
Bradley Corporation • 215-1480 Rev. E; EN 06-915 2/8/07
MG-2/TT Express® Lavatory System Dimensions
27"
(686)
47"
(1194)
54"
(1372)
42"
(1067)
15"
(381)
*Subtract 4" from vertical dimensions for compliance with ADA guidelines for children's use.
A
D
A
C
O
M
P
L
I
A
N
T
22"
(559)
*39"
(991)
*33-1/2"
(851)
*29-1/2"
(749)
*17-1/2"
(445)
21-1/2"
(546)
9-1/2"
(241)
(mm)
(mm)
(mm)
15"
(381)
Express® Lavatory System - MG-Series with TouchTime® Control
MG-2/TT Installation Instructions
4
2/8/07 Bradley Corporation • 215-1480 Rev. E; EN 06-915
Dimensions continued . . .
TAS Juvenile Height
Grades 6 thru 8 or 9
TAS Juvenile Height
Grades Pre-K thru 5 or 6
35-1/2"
(902)
30"
(762)
26"
(660)
14"
(356)
37-1/2"
(952)
32"
(813)
28"
(711)
16"
(406)
FLOOR
FLOOR
(mm)
(mm)
5
Express® Lavatory System - MG-Series with TouchTime® Control
Installation Instructions MG-2/TT
Bradley Corporation • 215-1480 Rev. E; EN 06-915 2/8/07
Installation Instructions
Step 1: Rough in supplies and optional hot water heater
NOTE: See Figure 1 (below), 1a, 1b (for TAS on page 6) and Figure 2 (on page 7) when roughing
in the MG-2/TT Express®.
IMPORTANT: Flush the supply lines before making connections. Debris in supply
lines will cause the valves to malfunction.
IMPORTANT: Dimensions shown in Figure 1 are for Standard Height Mounted
MG-2/TT Express®.
1. Rough in 1/2" NPT hot and cold supply lines through wall at dimensions shown.
2. Rough in 1-1/2" NPT drain waste connection through wall at dimensions shown.
3. OPTIONAL HOT WATER HEATER: Rough in appropriate electrical supply per local code
(recommended 240/208-volt or 277-volt electrical box location shown below).
4"
(102)
5"
(127)
FLOOR
APPROX. DIMENSION
14"
(356)
14"
(356)
*22-3/8"
(568)
*28-1/4"
(718)
*25-3/4"
(654)
1/2" NPT HOT AND COLD
SUPPLIES OR TEMPERED
SUPPLY – STUB OUT 2"
1-1/2" NPT DRAIN
STUB OUT 2"
110V GFI
PROTECTED
ELECTRICAL
OUTLET
3/8" WALLANCHORS (8) PLACES MIN. PULL-OUT
STRENGTH 1000 LBS. PER ANCHOR
*Juvenile Height Mounting:
Subtract 4" from vertical dimensions for compliance with ADA guidelines for children's use.
Figure 1
Standard Height Mounting
CENTERLINE
OF FIXTURE
*24-1/2"
(654)
*26"
(660)
*31-1/2"
(800)
3-3/4" (95)
*19-1/2"
(495)
4"
(102)
4" (102)
RECOMMENDED 240V/208V
OR 277V FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(2-1/2"l x 3"w x 4"h)
RECOMMENDED
240V/208V OR 277V
FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(4"l x 3"w x 4"h)
*23"
(584)
H
C
16-1/2"
(419)
25-1/2" (648)
APPROX. DIMENSION
25-1/2" (648)
A A
B
BB B
B
B
Express® Lavatory System - MG-Series with TouchTime® Control
MG-2/TT Installation Instructions
6
2/8/07 Bradley Corporation • 215-1480 Rev. E; EN 06-915
Figure 1a
TAS - Texas Accessibility
Standards:
Juvenile Height (grades
Pre-K thru 5 or 6)
4"
(102)
5"
(127)
FLOOR
APPROX. DIMENSION
14"
(356)
14"
(356)
18-7/8"
(479)
24-3/4"
(629)
22-1/4"
(565)
1/2" NPT HOT AND COLD SUPPLIES OR TEMPERED SUPPLY – STUB OUT 2"
1-1/2" NPT DRAIN
STUB OUT 2"
3/8" WALLANCHORS (8) PLACES MIN. PULL-OUT STRENGTH 1000 LBS. PER ANCHOR
CENTERLINE OF FIXTURE
21"
(533)
22-1/2"
(572)
28"
(711)
3-3/4" (95)
16"
(406)
4"
(102)
4" (102)
RECOMMENDED 240V/208V
OR 277V FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(2-1/2"l x 3"w x 4"h)
RECOMMENDED
240V/208V OR 277V
FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(4"l x 3"w x 4"h)
19-1/2"
(495)
H
C
16-1/2"
(419)
25-1/2" (648)
APPROX. DIMENSION
25-1/2" (648)
A A
B
BB B
B
B
Figure 1b
TAS - Texas Accessibility
Standards:
Juvenile Height (grades 6
thru 8 or 9)
4"
(102)
5"
(127)
FLOOR
APPROX. DIMENSION
14"
(356)
14"
(356)
26-3/4"
(679)
24-1/4"
(616)
1/2" NPT HOT AND COLD SUPPLIES OR TEMPERED SUPPLY – STUB OUT 2"
1-1/2" NPT DRAIN
STUB OUT 2"
3/8" WALLANCHORS (8) PLACES MIN. PULL-OUT STRENGTH 1000 LBS. PER ANCHOR
CENTERLINE OF FIXTURE
23"
(584)
3-3/4" (95)
18"
(457)
4"
(102)
4" (102)
RECOMMENDED 240V/208V
OR 277V FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(2-1/2"l x 3"w x 4"h)
RECOMMENDED
240V/208V OR 277V
FOR OPTIONAL
ELECTRICAL BOX
LOCATION
(4"l x 3"w x 4"h)
21-1/2"
(546)
H
C
16-1/2"
(419)
25-1/2" (648)
APPROX. DIMENSION
25-1/2" (648)
A A
B
BB B
B
B
30"
(762)
20-7/8"
(530)
24-1/2"
(622)
110V GFI
PROTECTED
ELECTRICAL
OUTLET
110V GFI
PROTECTED
ELECTRICAL
OUTLET
Loading...