Bradley Keltech Series Installation Manual
CNA Shown with
Deluxe Cart
Installation
Keltech® Portable Carts
For use with certain:
C1N Series - Light Industrial Heaters
C2N Series - Light Industrial Heaters
CNA Series - Large Industrial Heaters
Table of Contents
Safety Information ..................................2
Dimensions........................................3
Pre-Installation Information ...........................4
Storage Instructions .................................4
Mounting Heater to Cart..............................4
Heater Setup and Startup ............................5
Cart Options .................................... 6-7
215-1870 Rev. A; ECN 17-17-023
© 2017 Bradley
Page 1 of 7 7/21/2017
Keltech Incorporated
A Subsidiary of Bradley
729 S. Grove St., Delton, MI 49046
+1 269 623 6395 800 999 4320
Fax: +1 269 623 6398
www.bradleycorp.com
Keltech® Portable Carts Installation
WARNING
Tipover hazard. System can crush you resulting in serious injury or death. Read and follow precautions in this
installation manual that accompanied the heater for instructions on how to safely transport and anchor heater.
Always use caution while transporting heater.
Read this manual BEFORE using this equipment. Failure to read and follow all safety and user information
could result in death, serious personal injury, minor burns, property damage, or damage to the equipment.
Keep this Manual for future reference. Failure to comply with proper installation and maintenance instructions
could contribute to the heater’s failure.
A qualified plumber or electrician should install and service this system. Install system according to these
instructions and the instructions shipped with the heater as well as in compliance with national and local
codes.
ASSE standard 1016, 1069 or 1070 listed devices should be used at fixtures to prevent possible injury. Severe
bodily injury including scalding, chilling, and/or death may result depending upon system water pressure
changes and/or supply water temperature changes.
For safe operation of the heater, observe all warning labels as indicated.
Water heater system under pressure. Do not open enclosure while in operation.
These heaters should never be used to provide “anti-scald” or “anti-chill” service.
Hazardous voltage inside enclosure may result in serious burns or death. Disconnect power supply before
performing any work in the enclosure.
Failure to ground this system may result in death or serious injury.
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
CAUTION
Hot pipes! Do not touch. May cause minor burns.
NOTICE
These heaters do not provide protection from supply or outlet pipe freezing.
Consult local building and plumbing codes prior to installation. Should these codes differ from the information
in the Manual, follow the local codes. Inquire with governing authorities for additional local requirements.
Regular checking and cleaning of the heater’s internal components and check stops is necessary for maximum
life and proper product function. Periodic inspection and yearly maintenance by a licensed contractor is
required. Corrosive water conditions, and/or unauthorized adjustments or repairs could render the heater
ineffective for its intended service. Frequency of cleaning and inspection depends upon local water
conditions. For heaters with adjustable output temperatures, check and adjust as needed at initial installation
and on a quarterly basis.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file this
manual with the owner or maintenance department. Compliance and conformity to local codes and ordinances
is the responsibility of the installer. Product warranties may be found under “Products” on our Web site at
www.keltech-inc.com.
Separate parts from packaging and make sure all parts are accounted for before discarding any packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
2
7/21/2017 Bradley • 215-1870 Rev. A; ECN 17-17-023
Installation Keltech® Portable Carts
Dimensions
Portable C1N and C2N Series
with Deluxe Cart
44"
(1118)
40"
(1016)
Tool Box Included with
Deluxe Carts Only
11-7/8"
10-3/8"
(302)
Dimensions for deluxe cart shown.
Standard cart dimensions are identical.
51"
(1295)
39"
(991)
(264)
Truck Brake Included
with Deluxe Carts Only
Portable CNA Series
with Deluxe Cart
40"
(1016)
52"
(1321)
Tool Box Included with
Deluxe Carts Only
11-7/8"
(302)
59"
(1498)
39"
(991)
10-3/8"
(264)
Truck Brake Included
with Deluxe Carts Only
Bradley • 215-1870 Rev. A; ECN 17-17-023 7/21/2017
3
Loading...