Bradley Aerada 1200 Series, S53-325 Installation Manual
Installation
Aerada™ 1200 Series
CS Faucet
S53-325 Battery-Operated Capacitive
Sensing Gooseneck Faucet
Centershank with 4-inch Trim Plate
(Optional: 8-inch or No Trim Plate)
Table of Contents
Supplies Required.................. 2
Installation ..................... 4
Manual Settings ................... 6
Adjustments....................................9
Troubleshooting ................................10
Care and Maintenance ..........................12
Multi-Faucet Transformer Wiring ...................14
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Pressurized plumbing fixtures shall be installed in accordance with manufacturer´s recommendations. The
supply piping to these devices shall be securely anchored to the building structure to prevent installed
device from unnecessary movement when operated by the user. Care shall be exercised when installing the
device to prevent marring the exposed significant surface.
Separate parts from packaging and make sure all parts are accounted for before discarding packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Do not use pipe dope. Debris in supply lines can cause valves to malfunction. Possible valve
contamination could occur which will void any warranty. Teflon tape is the recommended sealant.
Product warranties may be found under “Products” on our web site at www.bradleycorp.com.
P.O. Box 309
+1 262 251 6000
bradleycorp.com
215-1641 Rev. E; ECN 16-02-002
© 2016 Bradley
Page 1 of 13 9/7/2016
Menomonee Falls, WI 53052 USA
800 BRADLEY (800 272 3539)
S53-325 Installation
Components for Model S53-325
Optional AC Adapters
(In Lieu of Battery Box)
.5 GPM Aerator Kit - 269-2482
1.5 GPM Aerator Kit - 269-1957
M4 x 25mm
Sink Ground
Kit (includes
ground wires,
spout lock
washer and
nut and sensor
washer)
Grounding Kit
(269-1889)
Earth
Grounding
Wire
Sensor
Washer
Insulator
Spacer (Red)
Screw
Spout Gasket
(269-1951)
Top Spacer
(269-1952)
Top Gasket
(269-1953)
Shank Nuts
3' ref.
4" Trim Plate Kit
(269-1955) included
8" Trim Plate Kit
(269-1956) Optional
3-in-1 Washer
(269-1911)
Single Unit Adapter
(153-443)
Order One Per Faucet)
5'
ref.
Battery Box
(S08-386)
6-Unit Adapter Box
(153-444)
Wire Assembly for
6-Unit Adapter Box
(269-1841)
Drain
Grounding
Wire
Black
Sensor Wire
Valve Control
Module
Valve Control Module Kit (153-447) includes:
• Control Module
• Grounding Kit
• Dirt Filter
• 1/2" NPS x 1/2" NPS x 12" hose included
• (4) Alkaline Batteries included
2
9/7/2016
Bradley • 215-1641 Rev. E; ECN 16-02-002
Installation S53-325
Attach Faucet and Trim Plate to the Deck
1
Drill two 3/8" (9.5mm)
diameter holes. Drill 1"
A
(25mm) diameter hole.
Sink/Counter Top
Trim Plate Studs
Optional Trim Plate Removal
Remove and discard long
trim plate screws and white
A
plastic screw spacers.
Attach trim plate studs
and secure trim plate
B
to sink using metal
washers and hex nuts.
Gasket and Faucet Spacers
After removing trim
plate, re-attach gaskets
and faucet spacer using
B
shorter M4 x 12mm screws
(supplied). Do not re-install
screw spacers.
Bradley • 215-1641 Rev. E; ECN 16-02-002 9/7/2016
Trim Plate
Red Plastic Screw Spacers
Long Trim Plate Screws
Short Trim Plate Screws
3
S53-325 Installation
Attach Activation Hardware to Faucet Shank
2
Tab on 3-in-1 washer must be
positioned 180 degrees opposite
tab on sensor connection washer.
Attach grounding
hardware to shank in
A
the order shown.
3-in-1 Washer
Attach activation
hardware to shank in
B
the order shown.
Connect the Valve Control Module
3
Brass Mounting Nut
Sensor Wire Connection Washer
Brass Mounting Nut
Place rubber washer
A
into white top nut fitting.
Hand tighten valve
control module to faucet
B
shank.
4
9/7/2016
Bradley • 215-1641 Rev. E; ECN 16-02-002
Loading...