Bradley 832-006-AMB, 832-005/6-AMB Datasheet

TECHNICAL DATA SHEET

SURFACE MOUNTED GRAB BAR

AMBULANT GRAB BAR
AND RAILS 832-006-AMB

- 32mm diameter

- Concealed fixing

- Standard - 450mm x 450mm

- Complies with AS1428.1

- Right and left-hand interchangeable

- For special sizes nominate:
Horizontal (A) =
Vertical (B) =

CONSTRUCTION:

FLANGES: Fabricated of type 304 (18-8), 80mm dia. 13 gauge

stainless steel.

ESCUTCHEONS: Fabricated of type 304 (18-8), 22 gauge stainless steel.

One-piece drawn construction with exposed surfaces in architectural

satin finish. Snap over flanges to conceal mounting screws.

TUBING: Fabricated of type 304 (18-8), 32mm (1-1/4") O.D.

18 gauge stainless steel, seamless construction with exposed surfaces

in architectural satin finish. Bent ends of tubing pass through the

flanges and are heliarc welded into a single structural unit for

maximum strength. Intermediate supports are contour cut and

joined by heliarc welding to form an integral part of the grab bar.

All welds ground and polished to blend. Mandrel bending process

maintains uniform bar diameter.

STRENGTH:

When properly mounted, all Bradley heavy duty grab bar systems

meet or exceed the requirements of Australian Standard AS1428.1(2,3),

of ANSI Standard A117.1, the ADA and ABA Accessibility Guidelines for

Buildings and Facilities (ADAAG) and the Uniform Federal Accessibility

Standard (UFAS).

MODEL 832-006-AMB

450mm

Polished (No. 4) satin finish
will not scratch hands
or catch dirt

Mandrel bending
process maintains
uniform
bar diameter

Bar heliarc welded
to flange to form
a single structural
unit for maximum
strength

Mounting holes

Escutcheon snaps over flange

to conceal mounting screws

Flange of 13 gauge type 304

o

90

18 gauge type 304

stainless steel

Flange escutcheon

stainless steel

450mm

INSTALLATION:

Secure to wall where adequate in-wall backing exists. Use bar as

template to locate mounting holes. Drill holes and set anchors as

appropriate. Mount grab rail and secure mounting screws. Snap

escutcheons into place.

GUIDE SPECIFICATION:

Grab bar shall be fabricated of type 304 satin finish stainless steel

with concealed mounting flanges in sizes and configurations as indicated.

TOLL FREE 1300 364 561

The manufacturer reserves the right to make changes in design and material

without formal notice and without incurring obligation.

16mm

*57mm

83mm

CONCEALED

*50mm wall clearance required

under most building design codes