Boss Audio Systems 622UA User Manual

Download

Page 1

iPod® is a trademark of Apple, Inc. registered in the U.S. and other countries.

Boss Audio Systems is not affiliated with Apple, Inc.

User’s Manual

622UA

IN-DASH SINGLE-DIN MP3-COMPATIBLE

DIGITAL MEDIA AM/FM RECEIVER

WITH USB AND SD MEMORY CARD PORTS

AND FRONT PANEL AUX INPUT

BOSS Audio Systems

-VOBS$PVSUt0YOBSE$"

www.bossaudio.com

800.999.1236

622UA

IN-DASH SINGLE-DIN MP3-COMPATIBLE DIGITAL MEDIA AM/FM RECEIVER

WITH USB AND SD MEMORY CARD PORTS AND FRONT PANEL AUX INPUT



tech support: www.bossaudio.com/support

Page 2

Page6

SPECIFICATION

GENERAL Supply Voltage DC 12V.NegativeGround Current Consumption Max.10A Power Output 4 x 50 W Number of channels 2 STEREO channels. Unit Dimensions (L X W X H): 7 X 3.85 X 1.97

FM SECTION Frequency range (Europe)

(U.S.A.) Effective sensitivity 3uV. I.F Frequency 10.7MHz.

AM SECTION Frequency range (Europe)

(U.S.A.) Effective sensitivity 40dB. I.F Frequency 450KHz

SD or USB PLAYBACK System MP3 audio system. Frequency characteristics 20Hz -100Hz

<=5

10KHz-20KHz

<=5

dB.

Signal to noise (SD & USB) 50dB [1KHz] .

”””

178 X 98 X 50 (mm)

87.5Mhz - 108Mhz

87.5 Mhz - 107.9Mhz

522Khz - 1620Khz 530khz - 1710Khz

Preamp Output 1 V Output

DESCRIPTION OF CONTROLS ON FRONT CONTROL PANEL

Front ControlPanel

Front Cabinetafter removing Front Control Panel

1. RELEASE button

2. SEL&VOLknob

3. POWER & MUTE button

4. LCD

5. SRC button

6. DISP button

7. BND/AP button 8&9. |<< And>>| buttons

10. 1/TOP/>|| button

11.2/INT button

191615

10 11

12. 3/RPT button

13. 4/RDM button

14. 5 DIR- button

15. 6 DIR+ button

16. USB PORT

17. Card slot

18. AUX IN jack

19. IR Remote Sensor

20. RESET button

21. FLASHING LED

RPT

MP3PLAYBACK 622UA

USB

PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com

Page 3

Page2

WIRES CONNECTION

ISO SOCKETSKETCH

CONNECTOR A

4. Memory +12V

5. Auto Antenna Output

7. 12V (To Ignition Key)

8. GROUND

CONNECTOR B

1. Rear Right Speaker (+)

2. Rear Right Speaker (-)

3. Front Right Speaker (+)

4. Front Right Speaker (-)

5. Front Left Speaker (+)

6. Front Left Speaker (-)

7. Rear Left Speaker (+)

8. Rear Left Speaker (-)

To boost up the capability of anti-jamming, please make sure fix tightly the support strap into the metal jointthatconnect to the chassis of the car.

metal

DASHBOARD

Bend the tabs on the metalmounting Sleeve against the DASHBOARD with

a screwdriver

METAL MOUNTING SLEEVE

METALSUPPORT STRAP

Toremove the unit out of the metal mounting sleeve, insert the two supplied KEYS into the left and right side slots of the chassis at the same time. Then pullthechassis out of the metal mounting sleeve as shown in the right illustration.

PLASTI C TRIM RING

FRONT PANEL

FIXED FACEPLATE

UNIT

CHASSIS

This is an anti-theft installation method.

The main unit wears a METAL MOUNTING SLEEVE.

Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below.

INSTALLATION METHOD

1.- REL BUTTON

2. - SEL & VOL CONTROL B UTTON

3. -POWER ON/OFF AND MUTE

4.LCD DISPLAY

5.SRC BUTTON

6 DISP button

7. - BND/AP BUTTON /

8&9. -TUNE, SEEK, TRACK, SKIP UP/DOWN BUTTONS

To remove the front panel from the main body,press the REL button.

A) Press the SEL repeatedly to s elect VOLUME - BASS - TREBLE - BALANCE - FADER. B)Press SEL button and hold for more than 2 seconds to turn on EQ OF F(P OP/ ROC K/ CLAS),then longpress SELbutton repeatedly to select , LOUD OFF/LOUD ON, BEEPOFF/ON,AREA(USA/EUR) in radio mode) mode.After selecting the desired mode, rotate the VOL- or VOL+ button to select one setupitem of the desired mode.

BEEPON/BEEPOFF BEEPON mode: The beep is generated when any key is pressed. BEEPOFF mode: The beep sound is disabled.

Press the POWER to turn on this unit. Toturn off the unit, press and hold this button unitit off.During playing, press this to mute the sound.

Press the SRC to select RADIO/CARD(SD card inserted)/USB(flash driverinserted)/ AUXmode. IN SD, and USB mode, press and hold SRC button to activateTRACK SEARCH and play the select track automatically.

. In USB/CARD mode, during playback, the ID3 tag information of the current track will display on the LCD. As long as the current playing music contains relevant ID3 tag information. Press the DISP to cancel the ID3 function, then the corresponding number of the currenttrack will display on the LCD.

A)Press the BND AP button to select radio band as follow:FM1 -> FM2 -> FM3 ->AM1

->AM 2. Press and hold the BND AP button to activate the auto storage function. The unitscans and preset the stationswith strongest signal.(18stations in FM or 12 stationsinAM )

A) Radio mode Press the>>I or I<< to perform manualseek tuning. Press and hold the >>I or I<< to perform auto tuning.The unit will tune to the station with strong si gnal. B) SD, and USB mode Press the >>I or I<< to play the next or previous track.

ISO SOCKET

WHITE

RED

RCA OUTPUT

ANTENNA JACK

PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com

Page 4

MUTE

DSP

SELEC T

A.P.

SCN

LOUD

LOC

BAND

MODE

TOP/

RDM

INT RPT

Page4

A)Radiomode Pressthe 1-6 buttons to selectthe preset stations. Press and hold the 1-6 buttons to store the stationthat currently listening. B) SD, and USB mode Press the >II to pause or resume playing. Press the INT to play the first 10 seconds of the tracks. Press again to off this function and the current track will ke ep playing. Press the RPTonce to repeat plays the current track. Press the RPT twice to repeat plays the current folder. Press the RP T thrice to repeat plays all tracks. Press the RDM to turn random play on or off. Press the 5/6 to play the next or previous folder.

When USB storage devi ce is connected, the unit is automatically switched to USB mode.

WhenSD card is inserted, the unitis automaticallyswitched to SD mode. (Note: if both USB stora ge device and SD card ins erted, the sy stem will swi tch to the mode of USB.)

Press the SRC to selectauxiliary input playing mode when connecting with external audio device.

The unit mustbe reset under the following conditions: A) Prior to using this unit forthe first time after installation. B) If the unit fails to operate properly,press the RESET with a pen tip or other pointed instrument.

10-15. - PRESET STATIONS MEMORY AND >II, INT,RPT, RD M BUTTONS

16. - USB PORT

17. - SD CARDSLOT

18. - AUX INPUT JACK (3.5MM STEREO JACK)

19.- IR Remote Sensor

20.- RESET BUTTON

21.- FLASHING LED

1. Power On/Off

2. Mute Butto n

3. Loudness Button This function enhances th e bass sound effec t given the low volum e leve l. Pres s the L OUD to turn on/off th e loudn ess fu nctio n.

4. SEL/MENU Button 5&6.VOL UP/DOWNButton

7. MO/ST Button Press the M O/ ST to select stereo or m o no so und mode under F M rad i o rece ption.

8. A.P Button Press the A.P but ton to preview the cu rr ent pr eset stations.(18 station s in FM ) Press a nd hold the A.P button to acti vate the auto stora ge fun ction. T he un it scans and pr eset the stations with stro ngest signal. (18st ations in FM )

9. Band Button

10. Mode Button

11. Tune/Seek Up And Track Skip Up/FF Butt on

12. Tune/Seek Down And Track Skip Down/REW Button

13. SCAN BUTTON Press the SC N butt on to scan the radio frequency. If a valid sign al has detected, th e current frequency will b e hold and blink ing for5seconds, then p ress S CN ag ain to stop scan an d rema in the current freq uency ; oth er wise, the radi o will go on to scan the other radio frequency 5 sec onds later.

14. DSP button In USB/CARD mode, during pla yback, the ID3 tag information o f the c urren t track will display on the LCD.As long as the currentplaying music contains relevantID3 tag information. Press the DSP to cancel t he ID3 f unction, then the corresponding number of the current track will display on the L CD.

15. LOC/DX B utton Local seeking tuning lets you tune in o nly tho se rad io stati on with suffi ciently strong signals for good receptions. Press LOC to select the lo cal ( LO) or distance (D X) mode on rad io rec eption . (Note: this func tio n only works on FM reception)

16. TrackTOP/>||/Radio Preset 1

17. Track INT/Radio Preset 2

18. Track RPT/Radio Preset 3

19. Track RDM/Ra dio Preset 4

20. Radio Preset 5 and USB/CARDDIR-

21. Rad io Preset 6 and USB/CARD DI R +

OPERATIONOF REMOTE CONTROL

PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com