Page 1
USER MANUAL
USER MANUAL
QUICK INSTALLATION GUIDE
MRGB65B
MARINE GRADE RGB 6.5” COAX SPEAKERS
QUICK INSTALLATION GUIDE
MRGB65B
MARINE GRADE
6.5″ COAX SPEAKERS
BOSS Audio Systems
3451 Lunar Court • Oxnard, CA 93030
www.bossaudio.com | 1.805.751.4853
Tech Support: www.bossaudio.com/technical-support
FEATURING 20 COLOR RGB LED’s
0416
MRGB65B-UM-DRAFT.indd 2-3 2/23/2016 3:51:27 PM
VER:1.0 EN
PRINTED IN CHINA
and RF REMOTE CONTROLLER
Page 2
TABLE OF CONTENTS
BEFORE YOU START ------------------------------------------------------------------2
IMPORTANT SAFETY PRECAUTIONS
INSTALLATION PRECAUTIONS
WIRE DIAGRAM-------------------------------------------------------------------------- 3
BEFORE INSTALLING THIS PRODUCT ------------------------------------------ 4
TECHNICAL SUPPORT
SUGGESTED MOUNTING LOCATIONS ------------------------------------------ 5
GETTING STARTED -------------------------------------------------------------------- 6
SPEAKER TEMPLATE ----------------------------------------------------------------- 7
TROUBLE SHOOTING GUIDE ------------------------------------------------------- 8
SPECIFICATIONS ------------------------------------------------------------------------ 8
TECHNICAL SUPPORT
All rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or
by any means, including photocopying, recording, or other electronic or mechanical methods, without the
prior written permission of Boss Audio Inc.
Copyright © 2016 Boss Audio Inc.
MRGB65B-UM-DRAFT.indd 4-5 2/23/2016 3:51:27 PM
Page 3
USER MANUAL
QUICK START GUIDE
Thank you for purchasing this
BEFORE YOU START
ENGLISH
IMPORTANT SAFETY PRECAUTIONS
MRGB65B 6.5” Coax Speakers w/ RGB LED RF Controller
Please read through these instructions carefully so you will know
how to operate your model properly.
After you have nished reading these instructions, keep this
document in a safe place for future reference.
THIS PACKAGE CONTAINS
2x- MRGB65B Coax Speakers
1x- RF Remote Controller
2x- Mounting Hardware Kit
1x- User Manual / 1x- Warranty Card
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of this device.
BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use caution or temporarily discontinue use in potentially hazardous
situations.
■ Do not operate mobile video equipment while driving a motorized vehicle
■ Safe vehicle operation and safety consideration of others should always
be your highest priority.
■ Set your volume control at a low setting, then slowly increase the sound
until you can hear it comfortably without distortion, or ear discomfort.
■ In the event you should notice smoke, strange noises or odor from this
product, or any other abnormal signs, immediately turn off the power and
consult your dealer or the nearest authorized BOSS AUDIO Service Center.
Using this product in this condition may result in permanent damage to the
system.
INSTALLATION PRECAUTIONS
WARNING - Always consult with a professional installer
■ Do not attempt to install or service this product by yourself. Installation or
servicing of this product by persons without professional training and
experience in electronic equipment and motorized vehicle accessories may
be dangerous and could expose you to the risk of electric shock, injury or
other hazards
■ Refer any repairs to a qualied BOSS AUDIO SYSTEMS Service Center
■ The MRGB65B LED RGB HUB should be wired directly to a normally open
switch or relay.
■ When wiring directly to the vehicles battery, be sure to disconnect the
batteries negative terminal wire before starting any wiring procedures,if extending the main power wire, it is suggested that an optional fuse and fuse
holder (not included) with minimum rating of 10 Amperes be in-line with the
positive battery terminal
■ The LED RGB HUB power cable length should be short as possible
■ The MRGB65B has a weather resistant design, it should not be submerged
in or under water under any circumstances
■ Use only the installation parts provided with the MRGB65B
MRGB65B-UM-DRAFT.indd 2-2 2/23/2016 3:51:29 PM
2
Page 4
ENGLISH
WIRE DIAGRAM
BEFORE INSTALLING THIS PRODUCT
ENGLISH
GROUND CABLE
CNO
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
CHASSIS
GROUND
POINT
FUSE / FUSE HOLDER
YOUR RADIO
REMOTE OUT
+12V BLUE
Normally Open
ON/OFF ACC switch
+12V RED
Normally open
ACC switch
(not included)
- Do not touch the speaker ex wire
- Secure all wiring with wire ties
3A
OPTIONAL
(NOT INCLUDED)
BLACK
CHASSIS
GROUND
POINT
METAL FRAME
+12V BATTERY YELLOW
YOUR
BATTERY
BATTERY
KILL SWITCH
Recommended 16 ~ 18ga Primary Extension Wire
FUSE AND FUSE HOLDER
(NOT INCLUDED)
(not included)
YOUR AMPLIFIER
OPTIONAL
+12VDC
SPEAKER 1
SPEAKER 2
RGB POWER
INPUT
To avoid potential shorts in the
electrical system, be sure to
disconnect the (–) battery cable before
installation. Use this unit with a 12-volt
battery and negative grounding only.
Failure to do so may result in a re or
malfunction.
When replacing the fuse, be sure to only use a fuse
of the rating specied on this product.
To avoid short-circuiting, cover any disconnected leads with insulating
tape. It is especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black cable
is ground, make sure to connect the ground wire rst.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame The ground cable of this units power amp and a
second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it
could result in re or malfunction.
- Properly seal connections to ensure water tight connections
TECHNICAL SUPPORT
1-805-751-4853
www.bossaudio.com/technical-support
TOOLS NEEDED:
- Wrench and/or Pliers
- #2 Phillips screwdriver
CAUTION!! Do not ground or short the RGB wires
3
MRGB65B-UM-DRAFT.indd 3-4 2/23/2016 3:51:29 PM
- Crimp tool
- Handsaw / Jig Saw
- Electrical tape
4
Page 5
SUGGESTED MOUNTING LOCATIONS
ENGLISH
The MRGB65B can mounted in three different congurations:
GETTING STARTED
ENGLISH
GETTING TO KNOW YOUR
MRGB65B RF CONTROLLER
Always double check for mounting
depth limitations, never cut before
you check
1
11
10
9
1
RF CONTROLLER
2
POWER ON / OFF
3
MODE UP
4
AUTO DEMO
5
SPEED UP
6
BRIGHTNESS UP
2
3
4
5
6
7
8
1) RF controller range: Up to 25ft (LoS)
2) Do not obstruct the RF remote with metal
3) Always keep away from small children
4) Do not store in direct sunlight
7
BRIGHTNESS DOWN
8
MODE DOWN
9
COLOR DOWN
10
CAUTION!! Using other mounting methods may void this warranty
5
MRGB65B-UM-DRAFT.indd 5-6 2/23/2016 3:51:29 PM
COLOR UP
11
SPEED DOWN
REPLACEMENT BATTERY - CR2025
6
Page 6
ENGLISH
EN
SPEAKER TEMPLATE
TEMPLATE FOR REEFERENCE ONLY - NOT TO SCALE
OD
TROUBLE SHOOTING GUIDE
TROUBLE CAUSE SOLUTION
The fuse is blown Check / replace the fuse
RGB Unit will not turn on
No sound is heard
Unit has become
unresponsive Power glitch or interference
Switch not engaged Turn to on position
Blown speaker Replace faulty speaker
Volume is low / muted Press the volume level up
Device is paused or muted
Check your devices playing /
volume status
Disconnect power for
10 seconds to reset
TECHNICAL SUPPORT
1-805-751-4853
www.bossaudio.com/technical-support
ENGLISH
SPECIFICATIONS
SPEAKER GENERAL SPEC
• Speaker Type: Full Range
• Conguration: Coaxial
• W o of er S i ze : 6 . 5 ”
• Tweeter Size: 1”
WATER DRAINAGE HOLE - DO NOT BLOCK
BE SURE TO MOUNT SPEAKER IN THE CORRECT ORIENTATION
TO ALLOW FOR WATER DRAINAGE
To avoid battery exhaustion be sure to run the vehicles engine
Tips:
while using this product. Using this product without running the
engine can drain the battery.
7
MRGB65B-UM-DRAFT.indd 7-8 2/23/2016 3:51:30 PM
• Mounting Depth: 2-5/8”
• Mounting Diameter: 5-3/4”
• Peak Power Handling: 200 Watts
• Impedance: 4Ω
• Sensitivity (1W/1M): 88dB
• Frequency Response: 70 Hz to 20 kHz, ±1 dB
ADJUSTMENT OR ALTERATIONS OF THIS DEVICE MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
RGB HUB GENERAL SPEC
• Power source: 14.4VDC (10.8V ~ 16V allowable)
• Grounding System: Negative type
• M a x i m u m C u r r e n t C o n s u m p t i o n : 1 . 5 A
• Unit Weight: 2.08lbs / 0.94kg
• Storage Temperature: 5oF to 113oF / -15oC to 45oC
• Operation Temperature: 14oF to 104oF / -10oC to 40oC
CAUTION!!
8
Loading...