Boss N140DW Assembly Guide

ASSEMBLY INSTRUCTIONS

MODEL N140-HUTCH WITH DOORS

COMPONENTS:
(1) BACK PANEL
(2) CENTER SHELF
(3) SHELF DIVIDER
(4) SIDE PANEL
(5) SIDE PANEL
(6) TOP PANEL
(7) DOORS
(8) TACK BOARD

STEP ONE:

PLACE BACK PANEL (1) ON FLAT SURFACE AND INSTALL CAM LOCKS (A) AND
DOWELS ○C
INSTALL CAM LOCKS (A) AND DOWELS(C) INTO CENTER SHELF (2) AND AFFIX TO BACK
PANEL (1) WITH KLIX CAMS (B) AS DIRECTED. SEE ILLUSTRATION (a).

STEP TWO:

LOCATE SHELF DIVIDER (3) AND PLACE SCREWS (G) INTO CENTER SHELF (2) DO NOT
TIGHTEN. SEE ILLUSTRATION ○C

INSTALL CAM LOCKS (A) AND DOWELS (C) INTO SIDE PANELS (4) AND (5) AFFIX TO BACK
PANEL (1) AND CENTER SHELF WITH KLIX CAMS (B) AS DIRECTED (b)

INSTALL CAM LOCKS (A) AND DOWELS (C) INTO TOP PANEL (6) THEN AFFIX TO SIDE
PANELS (4) AND (5), AND SHELF DIVIDER (3) WITH KLIX CAM (B)

TIGHTEN SCREWS (G) THROUGH CENTER SHELF (2) INTO SHELF DIVIDER (3). SEE
ILLUSTRATION (c)

STEP THREE:

INSTALL CENTER DOOR HINGES (D) TO INTERIOR DOORS (7) WITH SCREWS (H) AS
ILLUSTRATION (d) AND EXTERIOR DOORS (7) WITH SIDE DOOR HINGES (E) WITH
SCREWS(H). SEE DETAIL X-X FOR ALIGNMENT.

STEP FOUR:

INSTALL TACK BOARD INTO THE BACK WITH SCREWS (I) AS ILLUSTRATION(e). INSTALL
GROMMET (F) INTO BACK PANEL (1).

P.1/3