Bose 416549 User Manual
2.4GHz & 5 GHz RF Modular Transceiver System (Model 416549)
Installation manual
1. Description
This document describes an RF transceiver module supporting IEEE 802.11abgn
WiFi protocols, Bluetooth and Bluetooth Low Energy specification. The module
provides its own power regulation and shielding.
2. The module consists of:
1) 2.4 GHz Wi-Fi 802.11 b/g/n MIMO
2.) 2.4 GHz Bluetooth & Bluetooth Low Energy
3.) 5 GHz WiFi 802.11 a/n SISO with antenna diversity.
3. Cautions
This transceiver module is ONLY to be installed in Bose Corporation devices.
The module is to be surfaced mounted to a host printed circuit board with PCB etch
type antennas only. There are no antenna connectors used.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation
Changes or modifications not expressly approved by Bose Corporation could void the
user’s authority to operate the equipment.”
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
4. Markings
Pads 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
X
GND
(void)
GND GND SPI_DO GND GND GND GND GND STROBE3 LED0 GND RMII1_RXERR RMII1_CRS_DV GND
RMII1_REFCLK_50
M
RMII1_TXD0 GND GND GND GND GND GND GND GND I2C1_SDA GND GND
(void)
GND X
W
(void)
GND UART5_RXD GND GND BL_TXD GND GND
IR_IN_BL_R
XD
GND GND STROBE0 GND LED1 GND RMII1_TXD1 GND GND EMU0 GND GND SM2_1V5 SM2_1V1 GND VDD_3V6_IN_2 VDD_3V6_IN_2 GND SM2_1V8 GND
VDD_3V6_IN_
2
(void)
W
V
GND
LED3_MICROB_S
EL
UART5_TXD GND SPI_CLK G ND RMII1_TXEN GND GND GND GND GND EMU1 RMII1 _RXD0 MDIO_DATA GND MDIO_CLK RMII1_RXD1 GND SM2_1V8 _2 GND GND GND GND GND GND I2C1_SCL GND GND
VDD_3V6_IN_
2
GND V
U
(void)
NNMI GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND ETAP_TXD
(void)
LED2_MICROB_DE
T
SWITCH0N
NF_GPMC_A
D7
NF_GPMC_AD2
NF_GPMC_A
D4
(void) (void) (voi d) (void) (void) (void ) (void)
GND
VDD_3V6_IN_
2
(void)
U
T
(void)
ETAP_RXD NRESETIN_OUT
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
USB0_DRVVBUS GND
(void)
SWITCH2N STROBE1
NF_GPMC_A
D5
NF_GPMC_AD1
NF_GPMC_A
D3
(void) (void) (voi d) (void) (void) (void ) (void)
GND
VDD_3V6_IN_
2
(void)
T
S
GND SYNC_OUT GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
SWITCH1N C18_WIFI_EN
(void)
C18_BT_EN STROBE2
NF_GPMC_A
D6
NF_GPMC_AD0
(void) (vo id) (void) (void) (void) (voi d) (void) ( void)
GND P MIC_EN GND S
R
(void)
GND GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
SWITCH3N GND
(void)
GND GND
(void) (void)
NF_RE
(void) (void) (voi d) (void) (void) (void ) (void)
GND SM2_3V3
(void)
R
Q
(void)
GND AIN6_LIGHTSENSOR
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND DSP_RESETN
(void)
AUD2_IN_D0
HEADPHONE_
DETN
NF_CLE NF_ALE NF_WPN
(void) (void) (voi d) (void) (void) (void ) (void)
GND
VDD_3V6_IN_
1
(void)
Q
P
GND PORZ GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
DISP_PWR_EN_LED
7
AUD_OUT_D1
(void)
AUD2_FS AUD_IN_FS NF_WAIT NF_WE NF_CE
(void) (void) (voi d) (void) (void) (void ) (void)
GND
VDD_3V6_IN_
1
GND P
O
GND GND AIN4_PWRMON
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND T3_AMPFAULTN
(void)
GND GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND
VDD_3V6_IN_
1
GND O
N
GND GND GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND T3_AMPSTBYN
(void)
DISPDCN_LED5
ADC_DAC_RES
N
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND
VDD_3V6_IN_
1
GND N
M
GND
DISPCEN_LEDP
WM4
C18_PMIC_POWER
_EN
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
DISPRESN_LED6 C18_AM_TSYNC
(void)
GND
T3_MUTEOUT
N
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND
VDD_3V6_IN_
1
GND M
L
USB0_DM USB0_VBUS GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
PSM_DISABLE DSP_CSN
(void)
GND GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND
VDD_3V6_IN_
1
GND L
K
USB0_DP USB0_CE AIN0_5VMON
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND GND
(void)
SPI_DI
AM3356_JTAG
_TDI
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND GND GND K
J
GND AIN1_IDI N AIN3_PAOFFSET2
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND AUD_IN_BCLK
(void)
AM3356_JTAG_TD
O
GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND GND GND J
H
(void)
USB_FAULTN USB0_ID
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
AUD_OUT_D2/SPDI
F_OUT
GND
(void)
GND
AM3356_JTAG
_TMS
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND
ANT2_2G4_WI
FI_BT
(void)
H
G
(void)
ADCBIAS GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND AUD_OUT_MCLK
(void)
AM3356_JTAG_TC
K
GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND GND GND G
F
GND GND GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
AUD_OUT_BCLK GND
(void)
AM3356_JTAG_RT
CK
GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND ANT4_5G_WIFI
(void)
F
E
(void)
GND GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
GND AUD_IN_D0
(void)
AM3356_JTAG_NT
RST
GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND GND GND E
D
(void)
GND GND
(void) (void) (voi d) (void) (v o id) (voi d) (void ) (void) (void) (v oid)
AUD_OUT_FS GND
(void)
GND GND
(void) (void) (void) (void) (void) (voi d) (void) (void) (voi d) (void)
GND ANT3_5G_WIFI
(void)
D
C
GND GND AIN2_PAOFFSET1
AIN5_THERM
ISTOR
GND GND GND GND GND GND GND GND GND GND AUD2_BCLK GND GND GND GND SM2_1V8_3 GND GND WL_DBG
UART_DBUG_B
T
AUD_IN_BT
WL1837_JTAG_
TDI
WL_RS232_RX GND GND GND GND C
B
(void)
GND GND GND GND GND GND GND GND GND GND GND AUTH_RESETN GND GND GND GND GND GND GND
C18_HCI_RX_
BT
C18_HCI_CTS_BT C18_HCI_RTS_BT
AUD_CLK_OUT
_BT
AUD_OUT_BT
WL1837_JTAG_
TDO
WL1837_JTAG_TMSC18_HCI_TX_
BT
GND
ANT1_2G4_WI
FI
(void)
B
A
GND
(void)
LEDPWM0 GND GND GND GND GND GND GND GND GND GND GND GND GND GND GND GND GND GND WL_RS232_TX GND
AUD_FSYNC_O
UT_BT
GND GND
WL1837_JTAG_T
CK
GND GND
(void)
GND A
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
4.1 This module shall be identified with the following ID numbers on the radio
shields.
FCC ID : A94416549
IC : 3232A-416549
4.2 End Product Labeling
The final end product which this module is used in must be labeled in a visible
area with the following:
"Contains FCC ID: A94416549 / IC:3232A-416549"
5. The following table describes the module line grid array footprint.
6. General Electrical specifications
6.1 Power supply 3.6V +/- 5%
6.2 Power consumption <5 Watts
6.3 Operational Temperature 0 ~ 40 C
Loading...