Bosch Security Systems M514 Users manual

Telex Model BTR-800 Base Station

Owners/Users Manual (Preliminary Information)

General Description

The Telex Model BTR-800 is a part of the RadioCom ™ wireless intercom
series providing all of the Base Station functions.

The BTR-800 Base Station is a four channel receive and a two channel
transmit unit operating within the 518-608 and 614-746 MHz range (TV
Channels 22 to 59). Each base transmitter operates on selected frequencies
in the lower half of the frequency range and the receivers operate on selected
frequencies in the upper half of the frequency range.

The primary transmit frequency is used to transmit voice signals to all four
of the TR-800 portable (beltworn) units. The secondary transmit frequency
is used either as a second independent voice or signaling frequency. Each
transmitter is a full power unit (not a sub-carrier) that is fed to a power
combiner in order to reduce the number of antennas required for transmit.

Each of the base station receive frequencies are used to receive
transmissions from each portable unit. Full Duplex (telephone type)
operation is used and any portable can talk to any other portable or, any or
all of the base receivers can be deselected allowing the mobiles to monitor
only. Independent receive channels can be enabled or disabled by front panel
Pushbuttons. The presence or absence of a portable transmit is displayed on
the LCD Display.

Two independent 2 wire or 4 wire intercom units can be connected to the
base station. Each intercom has independent input and output level
adjustments.

An Auxiliary connector is provided for general audio use and also has input
and output level controls.

A local headset connector is provided with volume, audio channel A/B or
both, microphone gain control and a talk switch.

A front panel readout on the base station indicates the frequency or channel
that is in current use. A separate menu is used to select one of several

BTR-800 Users Manual Page 2

pre-programmed frequency sets or each base can be programmed to special
frequencies by the user.

The BTR-800 has a built-in 100 to 240 VAC 50/60 Hz power supply.
Power is controlled by the ON/OFF front panel switch.

Half (1/2) Wave antennas are supplied with the base station.
These antennas are ground independent. For improved range distance), Log
Periodic Antennas and various lengths of coaxial cable with connectors are
available as accessories.

Transmit (RF) power is switchable on the rear panel from 100mW
(maximum) to 10 mW (minimum). The transmit power can also be turned
off for use in multi systems where only one set of master transmitters is
desired. The low power setting can be useful where multi-system intermod
could occur or when it is desired to reduce the base transmitter range.

An Intercom (I/C) termination switch on the rear panel allows selecting
Telex, RTS or ClearCom connections.

Both Intercom A and B have XLR and RJ Connectors on the rear panel in
order to “Loop-Thru” to inter-connect several bases together.

The Auxilliary Audio Input and Output connectors are “one way” ports
that are useful for stand-alone applications.

The Stage Announce is an Audio Output useful for any announce or page
application . There is a dry “Relay Contact” (N.O.) also available on the
rear panel for switching applications when stage announce is activated.

END