Bosch SOLUTION 6000 Quick User Manual

For Sales & Service, Please Contact;

Electronic Security & Data Communications

Phone: [phone]

www.bjrsecurity.com.au

This document has been designed as a quick users guide for the Bosch Solution 6000 and Bosch Solution 144

alarm system. Please refer to the full users guide provided for more information when operating the system.

A copy of the full users guide can be downloaded from our website www.bjrsecurity.com.au/downloads.htm

SCAN HERE TO VISIT

OUR DOWNLOADS PAGE

Document: BJR-B6000-QUG V03 Updated: 16 JAN 2015

Copyright BJR Security 2015

ALARMS MONITORING CCTV ACCESS CONTROL PHONE & DATA CABLING

BOSCH SOLUTION 6000

QUICK USERS GUIDE

Keypad Display Icons & Meanings

How To Arm

To arm the whole alarm

Enter your 4 digit code then the [ON] button

If there are any zones unsealed (exept zones set to not test as programmed by your installer) when you

arm the system, or any system faults, you may be asked to press [OK] to force On or Bypass them.

Please contact BJR Security if this is re occurring.

To arm in partial mode

Enter your 4 digit code then the [PART] button

(Only zones discussed with your installer at time of installation will be armed in this mode)

How To Disarm

Enter your 4 digit code then the [OFF] button

Using The 4 Button Remote Controls (optional add on)

To use the remote, press and hold a button for approx 2 second until the red light comes on.

Arm the system (Full arm mode)

Disarm the system
Arm the system in partial mode

Optional Output Control _________________________________________

How To Change Own PIN Code

Every user code can change their own code, however only the 'master code' (user 1) can be used to add, change or

delete codes other than their own.
If you only have 1 code, typically this will be the 'master code'

1. Enter your PIN code then press [MENU] then [1] then [1] then [0]

2. Enter your new PIN code then press [OK]

3. If prompted, re enter your new PIN code then press [OK]

4. Hold down the [MENU] button for approximately 2 seconds until you exit from the menu.

If you have the 'master code' and wish to add or change other codes, please refer to the full users guide.