9000 293 516 (8711)
Demo-model with water circulation
-Install the dishwasher with the help of a air level.
-Before start-up close the drain hose with the delivered plug!
-To start-up fill into the container distilled water (Quantity approx.
4liters).
-No using of detergent or rinse-aid!
-To activate the dishwasher switch on the main-button. Then push the ECO 50 program button and finally the start key. For operating only closing the door.
-After the program - end the dishwasher can be activated by opening the door and activating the start key again.
-Water change after 10 days approximately.
-For the water change or water removal
Remove the plug from the drain hose. Put the drain hose into a sufficiently large container. By pressing the start key (RESET)
3seconds the water is pumped into the container. At the display
0:01 is indicated. The cancelling procedure is started by closing the door.
-Before start-up close the drain hose with the delivered plug!
-Electrical connection 230 V alternating current (AC)
-Continuous working maximum 8 hours.
In the case of breakdown:
Tel. 0049-9071-52-451 (Herr Singer/Herr Demharter)
, Safety Instructions
Operation of the DEMONSTRATION MODEL
This DEMONSTRATION MODEL is only for supervised operation in showrooms and at exhibitions. Sale to an end customer is not allowed.
The DEMONSTRATION MODEL is a modified version of a series appliance with all the safety functions of a series appliance. However, through the modifications made in order to demonstrate the main features, the appliance has been modified to such an extent that it is necessary to carry out an additional subsequent check, to ensure safe operation of the appliance and the perfect condition of all the modifications.
Before initial use:
Only plug this DEMONSTRATION MODEL into an electric socket protected by a Type A current-operated circuit breaker permitting a nominal circuit-breaking current of max. 30 mA. Such a current-operated circuit breaker is marked with the symbol .
Check to ensure that the socket ground wire the has been properly connected as per the regulations.
Never set up the appliance near sources of heat (radiators, heating tanks, ovens or other devices which give off heat).
After setting up the appliance the plug must still be freely accessible.
The plastic housing near the water connection contains an electrically operated valve and the connection lines are located in the inlet hose. Do not cut through this hose or submerge the plastic housing in water.
Check before each use:
All housing parts and above all the plastic display windows of the appliance must be undamaged.
The plastic display windows must be watertight. Check round the edges of the windows for signs of water leakage or gaps; especially round the inner plastic display windows.
While in operation:
During operation, look out to ensure that the display windows and the appliance show no signs of leakage. This may be indicated by dribbles of water or puddles.
If damage (except minor, superficial damage) or leakage is detected, the DEMONSTRATION MODEL may no longer be used and must be disconnected immediately from the mains supply by pulling out the plug. It must also be ensured that the appliance cannot be switched on again in this condition.