Bosch SHU33A, SHU43A, SHU53A, SHU66A, SHU43E Installation Instructions Manual

Installation

LAVADO_ DE PLATO$

SHU33Ar SHU43Cr SHUS3AI SHU66Cr
SHU43Er SHU53EI SHU66Er

SHV46Cr SHV66AI

SHX33Ar SHX46Ar SHX46BI SHXS6BI

SHYS6A/$HY66C

TABLE OF CONTENTS

INTRODUCTION ................................................... 2

TOOLS AND MATERIALS NEEDED .......................... 3

MATERIALS SUPPLIED ........................................... 4

CHOOSING LOCATION .......................................... 5

PLUMBING PREPARATION ..................................... 6

ELECTRICAL PREPARATION ................................... 7

PLACING THE DISHWASHER ................................. 8

DRAIN HOSE CONNECTION .................................. 9

HOT WATER CONNECTION .................................. 10

ELECTRICAL SUPPLY CONNECTION ...................... 11

GROUNDING INSTRUCTIONS ............................... 11

DOOR PANEL INSTALLATION ........................ 12 & 13

FINAL AD]USTMENTS .......................................... 14

BASE AND TOE PANEL .......................................... 15

TOE PANEL AND HANDLE ..................................... 16

FINAL CHECKLIST ................................................ 17

IMPORTANT: Before you begin, read these instructionscompmetely and carefully,

INSTALLER: Please leave this manual with owner for future reference,

OWNER: Save these installation instructions for local

electrical inspector's use and for future reference,

www,boschappliances,com ENGLISH =1

THESE INSTALLATION INSTRUCTIONS ARE INTENDED

FOR USE BY QUALIFIED INSTALLERS,

Xn add(tion to these instructionsthe dishwasher shall be installed:

(n the Un(ted States, (n accordance w(th the Nat(ona) Electr(c
Code/State and Municipal codes and/or local codes,

• In Canada, in accordance with the Canadian Electric Code
C22_1 =latest edition/Provincial and Municipal codes and/or

local codes,

Please read these installation inst:ructions completely and carefully,

They will save you time and effort and help to ensure optimum dishwasher

performance,

Be sure to observe all listed

warnings and cautions. (Look for
the triangles with e×clamation marks

(ns(de,)

NEW INSTALLATION = ]:f the dishwasher (s a new insta(lation, most of the work
must be done before the dishwasher is moved into place°

REPLACEMENT - If the dishwasher is replacing another dishwasher, the

connections for the dishwasher being replaced must be checked for

compatibHi_with the new dishwasher and replaced as necessary,

INSPECT THE DTSHWkSHER

After unpacking the dishwasher and prior to insta((ation_ thoroughly inspect the
dishwasher for possible freight or cosmetic damage, Report any damage immediately,

Cosmetic defects must be reported within 5 days of installation,

NOTE: Please do not discard any bags or items that come with the

original package until after the entire installation has been completed!

= _GLTS_ www,boschapp(ia.ces,com

TooLs Needed for Installation

Hammer

Hole saw or 1" hole cutter

Pipe wrench, 2 reqd.

o)

Adjustable wrench,

(size med., 2 reqd.)

Wire stripper

Tape Heasure

Wire Cutter

Electric Drill

Slotted screwdriver (#2)

Phillips screwdriver (#2)

Torx screwdriver, #20

Figure 1

Materials Needed

1

Electric Connection - 2 conductor, 1 ground
insulated electrical supply cable (30" or

suffident length for your installation),

3

Hot Water Supply Line - Hinimum 3/8"
O.D, copper tubing or metal braided
dishwasher supply Iineo

Shut-off valve and fittings for hot water
supply line.

4

90° elbow with 3/8" N.RToexternal threads

on one end and sized to fit your water

supply line on the other end°

5

Teflon tape or other pipe thread compound
which help seal plumbing connectionso

6

3 twist-on wire connectors for 16 AWG

wireo

UL listed conduit connector or strain relief.

Additional materials may be required to comply with local cedes,

Figure 2

www,boschappiiances,com _N_LT_ - 3

Accessory Parts Supplied

Accessory Parts for your model dishwasher will
come in one or more plastic bags, Check to

make sure that the parts supplied for your
model are all there, See Figure 3. If any parts

are missing contact your dealer immediately.

DISHWASHER

%NSTALLATION KIT (Clear Bag)

D, Toe Panel Screws (Smm) (2)
E. Mounting Brackets (1L & 1R)
F. Mounting Bracket Screws (2)
G. Rubber Connection Hose (1)

and Drain Hose Clamps (2)

$HY66 & $HXS6 Models

Dishwasher InstallationKit(i) and

(Green Bag) wi the following:
L. J-Box Cover (1)

M, 3-Box Screw (8ram) (1)
N. Toe Panel Screw (4x16) (2)

$HV and SH][ Models

Dishwasher InstallationKitand
Outer Door InstallationKit(Blue bag):

J. SHIiSHV Panel Installation Template

C, Cap (2 BIk)
K. Wood Screws (2)
1". Mounting Door Brackets(2 plastic)

w/Screws (4) and;
Mounting Door Brackets (2 metal)
w/Screws (4)

H. Spring Tension Screw (2)

Manual Bag

All Dishwashers come with a manual bag,
The following contents are located in every

bag:
® Use &Care Manual

® Installation Instructions

P. Tall Item Sprinkler (1)

SHY66 & SHX56 models
have an additional part:

Q, Cotton Insulation Strip (1)

Note: Pictures are not to scale. Figure 3

4- ENGLISH www.boschappiiances.com

THBEIN AW ON

INSTRUCTIONS

INTENDEDFORU_ BY

QU_EDINSTALLE_ 1

Choosing the Location

Select a locationas close to the sink as
possibleforready accesstowater and drain

lines.
Most of the installation work is done before

the dishwasher is moved into place.

Any built-in dishwasher must be fully
enclosed on the top, both sides and back.
Therefore the cabinet space below your
counter is probably the best location.

For proper operation and appearance of the

dishwasher, the cabinet opening should be
square and have dimensions as shown in

Figure 5.

(49ram)

Figure 4

23-9/16" (598 mm) "_

/F /S'I _'

....j

23-5/8" - 24-1/8" (600-613 cam)

Figure 5

If the dishwasher is to be installed in a

corner, make sure there is adequate clea-

rance to open the door. See Figure 6.

Clearance-

o0on,o /11 I

oDpOrnin L

)osition

Dishwasher

Countertop

Figure 6

www,boschappliances,com FNGL]:SH - 5