Bosch HEZ9ZZ30UC, HEZ9ZZ36UC, HEZ8ZZ30UC, HEZ8ZZ36UC Installation Manual

Island Trim

Installation Manual

HEZ9ZZ30UC, HEZ9ZZ36UC, HEZ8ZZ30UC, HEZ8ZZ36UC

ö Installation Instructions

9 Safety Definitions ..................................................... 3

IMPORTANT SAFETY INSTRUCTIONS ........................ 4

Before You Begin .......................................................... 5

Parts Included ....................................................................... 5

Tools and Parts Needed ..................................................... 5

Cabinet Requirements ......................................................... 5

Installation Procedure ................................................... 5

STATEMENT OF LIMITED PRODUCT WARRANTY .... 6

What this Warranty Covers & Who it Applies to ............. 6

How Long the Warranty Lasts ............................................ 6

Repair/Replace as Your Exclusive Remedy ................... 6

Out of Warranty Product ..................................................... 6

Warranty Exclusions ............................................................ 6

Obtaining Warranty Service: ............................................... 7

Purpose

Thank you for purchasing an island trim accessory for
your Bosch Industrial Style Range.

The purpose of this trim piece is to cover the gap created
when an appliance is installed 3” from the rear wall of the
kitchen.

9 Safety Definitions

9 WARNING

This indicates that death or serious injuries may
occur as a result of non-observance of this warning.

9 CAUTION

This indicates that minor or moderate injuries may
occur as a result of non-observance of this warning.

NOTICE: This indicates that damage to the appliance or property may occur as a result of non-compliance with this advisory.

Note: This alerts you to important information and/or tips.

Safety Definitions

3

9 IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY I NS TRU CTI ONSREAD AND SAVE THESE INSTRUCTIONS

Wear gloves to avoid cutting fingers on sharp edges
during Installation.

Hidden surfaces may have sharp edges.
Use caution when reaching behind or
under appliance.

4

Before You Begin

Before You Begin

Parts Included

Tools and Parts Needed

▯ Phillips head screwdriver
▯ Gloves

Cabinet Requirements



$

▯ Option 1: A >= 12'' (305 mm) and B >= 28'' (711 mm)
▯ Option 2: A >= 28'' (711 mm) and B >= 12'' (305 mm)

* purchased separately
** Clearances from non-combustible materials are not

part of the ANSI Z21.1scope and are not certified by
“Intertek”. Clearances of less than 3'' (76 mm) should be
approved by the local codes and/or by the local authority
having jurisdiction.

PLQ



%

Installation Procedure

1.

Remove any protective film.

2.

Remove the screws shown in the diagram below and

Installati on Procedure

retain for step 3.

3.

Affix the trim with the 4screws removed in step 2.

5