Bosch HEZ1080 User Manual
Installation Manual
Guide d’installation
Manual de instalación
Gas Cooktop Low Profile Kit
Model: HEZ1080
Installation
Before you Begin
This kit is required in order to install a Built-in 2007 series, single 30” oven under any Bosch 30” gas cook tops.
IMPORTANT:
This kit is designed specically for Bosch produced gas cook tops and is not recommended for any other installation.
WARNING:
SHUT OFF THE GAS SUPPLY AND DISCONNECT THE MAIN POWER TO THE APPLIANCE BEFORE
INSTALLING THIS KIT.
WARNING:
Improper installation, adjustment, alteration, service, or maintenance may cause injury or property damage.
Refer to the cooktop installation manual. For assistance or additional information, consult a qualied
installer, service agency, manufacturer, or gas supplier.
Parts Included
1 Low Prole Elbow Brass Connection
1 STD ½” NPT Brass Street Elbow
1 STD ½” NPT x 1 ½” Brass Nipple
Installation Procedure
To ensure proper installation, all steps must be followed in the correct order as listed below.
IMPORTANT:
All threaded connections must use an appropriate gas sealant.
Install the low prole elbow to the gas cooktop connector, ensuring that the inlet to the elbow is facing the rear of the
1.
unit as shown in Figure 1: Step 1 below.
Cooktop Back
Figure 1: Step 1
Thread the provided street elbow on the low prole elbow.
2.
Thread the provided nipple and the regulator from the cooktop to the street elbow. See Figure 2: Low Prole Kit
2 ¾”
2 ½”
21 ½”
3.
Installation Assembly for proper installation.
Cooktop Back
Figure 2: Low Prole Kit Installation Assembly
The completed installation should look like Figure3: Final Assembly below.
Figure 3: Final Assembly
In order to avoid conicting installation with the wall oven, all remaining gas piping must lie in the shaded region of the
4.
following diagram.
Cooktop
Oven
Figure 4: Gas Piping Location
Loading...