Page 1
Video | EX70 Compact Explosion‑protected Camera
The EX70 is a small, tough, compact, explosion-protected
camera with performance optics for safe, effective
surveillance in hazardous locations such as in oil and gas,
and chemical facilities.
The EX70 is certified for ATEX Zone 1 or NEC Class I,
Division 1 environments, the most stringent safety
standards for explosion-protected performance. By
definition, the Class I, Division 1 certifications signify that
the EX70 is safe for use even in environments where
explosive gases are present under normal operating
conditions.
The EX70 incorporates high-strength design, featuring a
construction of sand-cast, copper-free aluminum, strong
enough to withstand an internal explosion. Threaded
flame paths extinguish burning explosive gases and allow
them to exit the housing harmlessly, without risking
ignition in the external environment.
By meeting the rigorous requirements for Class I,
Division 1 environments, the EX70 assures safe, effective
performance at less hazardous Division 2 and Class II
locations.
Rated NEMA 4X for both indoor and outdoor use, the
EX70 carries a T6 temperature code, the lowest and safest
rating. The EX70 is available with either a 3.6 mm or
6.0 mm fixed lens and is easy to install into any 12 VDC or
24 VAC system. It is a safe and effective surveillance
solution for hazardous locations.
Functions
Performance Optics
•
Performance CCD with mechanical filter technology
•
Enables effective surveillance in low-light
environments
•
Sensor provides higher IR sensitivity, low smear, low
streaking and excellent anti-blooming characteristics
Compact Ruggedized Construction
•
Small, unobtrusive and discreet housing
•
NEMA 4X design for indoor and outdoor performance
•
High-strength reinforced aluminum construction
strong enough to withstand an internal explosion.
•
Threaded flame paths extinguish burning explosive
gases, allowing them to exit the housing harmlessly
without risking ignition in the external environment
Installer-Friendly Features
•
Fixed 3.6 mm or 6.0 mm lens
•
12 VDC / 24 VAC operation
•
Optional pan-tilt brackets
•
Optional wall and pole adapter plates
Applications
•
Petroleum processing facilities
•
Chemical factories
•
Agricultural processing plants
•
Refineries
•
Munitions storage
•
Oil and gas plants
•
Fuel storage sites
•
Industrial plants
•
Nuclear facilities
EX70 Compact Explosion‑protected
Camera
▶
UL/CSA or ATEX certified for explosion-protected
performance
▶
Class I, II, III, Div. 1, 2, Groups B, C, D, E, F, G, T6,
Ex II 2 G, Ex d IIC T6
▶
Performance optics with mechanical filter technology
▶
High-strength design can withstand an internal
explosion
▶
Small, compact housing, NEMA 4X rated
▶
Safe for use where explosive gases are normally
present
www.boschsecurity.com
Page 2
2 | EX70 Compact Explosion‑protected Camera
•
Pharmaceutical plants
•
Aircraft hangers
Certifications and Approvals
Region Certification
Europe CE
ATEX
CSA/NRTL LR 113310
Class 2258 / 82 – Process Control Equipment – For Hazardous
Locations – Certified to US Standard
2258 / 02 – Process Control Equipment – For Hazardous
Locations
Safety UL / CSA / ATEX
UL 508, 16th Edition – Industrial Control Equipment
UL 698, 11th Edition – Industrial Control Equipment for
Use in Hazardous (Classified) Locations
UL 1203, 2nd Edition – Explosion-Proof and Dust-IgnitionProof Elec. Eqmt for Use in Hazardous (Classified) Locations
CSA C22.2 No.0-M1991 – General Requirements – Canadian Electrical Code Part II
CSA C22.2 No.0.4-M1982 – Bonding and Grounding of
Electrical Equipment (Protective Grounding)
CSA C22.2 No.25-M1966 – Enclosures for Use in Class II
Groups E, F and G Hazardous Locations
CSA C22.2 No.30-M1986 – Explosion-proof Enclosures
for Use in Class I Hazardous Locations
CSA C22.2 No.94-M1991 – Special Purpose Enclosures
CSA C22.2 No.142-M1987 – Process Control Equipment
Class I, Division 1 and 2, Groups B, C, and D
Class II, Division 1 and 2, Groups E, F, G
Class III
ATEX Ex II 2G certified – Equipment or Protective System
intended for use in Potentially Explosive Atmospheres; Directive 94/9/EC
ATEX Ex d IIC T6 certified – Equipment or Protective System intended for use in Potentially Explosive Atmospheres; Directive 94/9/EC
Operational Temperature Code T6 (At ambient operational temperature
of 40ºC, the maximum unit surface temperature will not exceed 85ºC.)
Environmental
CSA / NEMA TYPE 4X
Installation/Configuration Notes
Dimensions
117 (4.63)
98 (3.85)
83 (3.25)
111 (4.38) mm (in)
Ø7.6 (0.30)
2x
6.3
(0.25)
117 (4.63)
Flexible Mounting Options
•
Wall mounting
-
use a combination of EXMB.070B (EX70 adapter
plate), EXMB.028B (pan/tilt bracket) and EXMB.
017B (wall mount adapter).
•
Pole mounting
-
use a combination of EXMB.070B (EX70 adapter
plate), EXMB.028B (pan/tilt bracket) and EXMB.
015B (pole mount adapter).
•
Ceiling mounting
-
use a combination of EXMB.070B (EX70 adapter
plate) and EXMB.002B (ceiling bracket).
All brackets are available as optional accessories.
Technical Specifications
Color Cameras
CCD MX4 CCD Mechanical
Filter
C7 High Resolution Color
Image Sensor 1/3 in CCD 1/3 in Interline Super-
HAD
Resolution 540 TVL color/ 540 TVL
mono
500 TVL
Effective Pixels
(NTSC)
768 (H) x 494 (V) 768 (H) x 494 (V)
Effective Pixels
(PAL)
752 (H) x 582 (V) 768 (H) x 582 (V)
Sensitivity 0.02 lx at F1.4 2.7 lx at F1.4
S/N Ratio Greater than 48 dB Greater than 48 dB
Output Signal 1 Vpp, 75 ohm
BLC On / Off selectable
Gain Control AGC automatic
Electronics Iris 1/60 to 1/100,000
(NTSC)
1/50 to 1/100,000
(PAL)
Voltage 12 - 24 VAC (50/60 Hz)
12 - 24 VDC
Power consumption 3.9 W max.
Page 3
EX70 Compact Explosion‑protected Camera | 3
Operation Temperature Range
-50 ºC to +40 ºC (-58 ºF to 104 ºF)
Weight 1.4 kg (3.1 lbs)
Dimensions 117 x 117 x 99 mm (4.6 x 4.6 x 3.9 in)
Construction Powder-coated copper-free cast aluminum with
two 3/4-inch NPT conduit entries
Note To order a CSA/ UL certified product use
product codes without the AT suffix. To order
an ATEX certified product use product codes
with the AT suffix.
Ordering Information
EX70MX404-N Compact, Explosionprotected Camera
Day/Night 1/3 in. CCD, 540/540 TVL, mech.
filter, 3.6 mm fixed lens, NTSC, CSA/UL Certified
EX70MX404-N
EX70MX404-P Compact, Explosionprotected Camera
Day/Night 1/3 in. CCD, 540/540 TVL, mech.
filter, 3.6 mm fixed lens, PAL, CSA/UL Certified
EX70MX404-P
EX70MX406-N Compact, Explosionprotected Camera
Day/Night 1/3 in. CCD, 540/540 TVL, mech.
filter, 6.0 mm fixed lens, NTSC, CSA/UL Certified
EX70MX406-N
EX70MX406-P Compact, Explosionprotected Camera
Day/Night 1/3 in. CCD, 540/540 TVL, mech.
filter, 6.0 mm fixed lens, PAL, CSA/UL Certified
EX70MX406-P
EX70C704‑N Compact, Explosionprotected Camera
1/3 in color CCD, 500 TVL, 3.6 mm fixed
lens, NTSC, CSA/UL Certified
EX70C704‑N
EX70C704‑P Compact, Explosionprotected Camera
1/3 in color CCD, 500 TVL, 3.6 mm fixed
lens, PAL, CSA/UL Certified
EX70C704-P
EX70C706‑N Compact, Explosionprotected Camera
1/3 in color CCD, 500 TVL, 6.0 mm fixed
lens, NTSC, CSA/UL Certified
EX70C706‑N
EX70C706‑P Compact, Explosionprotected Camera
1/3 in color CCD, 500 TVL, 6.0 mm fixed
lens, PAL, CSA/UL Certified
EX70C706‑P
EX70MX404AT-N Compact, Explosionprotected Camera
Day/Night 1/3 in CCD, 540/540 TVL, mech.
filter, 3.6 mm fixed lens, NTSC, ATEX Certified
EX70MX404AT-N
Ordering Information
Accessories
EXMB.015B Pole Mount Adapter Bracket
Pole Mount Adapter, black
EXMB.015B
EXMB.017B Wall Mount Adapter Bracket
Wall Mount Adapter, Black
EXMB.017B
EXMB.028B Cable Managed Wall Bracket
Cable-managed arm bracket, black
EXMB.028B
EXMB.070B Adapter Bracket
Aluminum adapter bracket for EX70
EXMB.070B
EXMB.002B Ceiling and Pedestal Bracket
Ceiling and Pedestal Bracket, Black
EXMB.002B
UPA-2430-60 Power Supply
120 VAC, 60 Hz, 24 VAC, 30 VA Out
UPA-2430-60
UPA-2420-50 Power Supply
220 VAC, 50 Hz, 24 VAC, 20 VA Out
UPA-2420-50
www.boschsecurity.com
Page 4
4 | EX70 Compact Explosion‑protected Camera
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
[email protected]
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5600 JB Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
[email protected]
www.boschsecurity.com
Asia-Pacific:
Robert Bosch (SEA) Pte Ltd, Security Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6258 5511
Fax: +65 6571 2698
[email protected]
www.boschsecurity.asia
Represented by
© Bosch Security Systems 11 | Data subject to change without notice
T5999670923 | Cur: en-US, V15, 7 Jun 2011
Loading...