Bosch DWA072450B, DWA092520B, DWA062560B, DWA062450B, DWA092450B User Manual

...
Operating and installation instructions
2
Abb. 1
ELECTRO
Fig. 1 GAZ
3
Operating modes
Exhaust-air mode:
The extractor-hood fan extracts the
kitchen vapours and conveys them through the grease filter into the atmosphere.
The grease filter absorbs the solid
particles in the kitchen vapours.
The kitchen is kept almost free of grease
and odours.
D
When the extractor hood is operated in exhaust-air mode simultaneously with a different burner which also makes use of the same chimney (such as gas, oil or
coal-fired heaters, continuous-flow heaters, hot-water boilers) care must be taken to
ensure that there is an adequate supply of fresh air which will be needed by the
burner for combustion. Safe operation is possible provided that the
underpressure in the room where the burner is installed does not exceed 4 Pa (0.04 mbar).
This can be achieved if combustion air can flow through non-lockable openings, e.g. in doors, windows and via the air­intake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc.
If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room.
An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be exceeded.
Note: When assessing the overall requirement, the combined ventilation system for the entire household must be taken into consideration. This rule does not apply to the use of cooking appliances, such as hobs and ovens.
Unrestricted operation is possible if the extractor hood is used in recirculating mode – with activated carbon filter.
Instructions for use:
Circulating-air mode:
An activated carbon filter must be fitted
for this operating mode (see Filters and maintenance).
The complete installation set and
replacement filters can be obtained from specialist outlets.
The corresponding accessory numbers can be found at the end of these operating instructions.
The extractor-hood fan extracts the
kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen.
The grease filter absorbs the grease
particles in the kitchen vapours.
The activated carbon filter binds the
odorous substances.
If no activated carbon filter is installed,
it is not possible to bind the odorous substances in the cooking vapours.
4
Before using for the first time
Important notes:
The Instructions for Use apply to several
versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance.
This extractor hood complies with all
relevant safety regulations. Repairs should be carried out by
qualified technicians only.
Improper repairs may put the user at considerable risk.
Before using your appliance for the first
time, please read these Instructions for Use carefully. They contain important information concerning your personal safety as well as on use and care of the appliance.
Please retain the operating and
installation instructions for a subsequent owner.
Gas hobs / gas cookers
Do not operate more than 2 gas
cooking areas simultaneously over a period of max. 15 minutes at maximum thermal load. Due to the effect of the heat there is a risk of burns if the surfaces of the housing are touched.
Note that one large burner of more than
5 kW (Wok) is equivalent to the power of 2 gas burners.
Never operate a gas cooking area
without a cooking utensil on it. Regulate the flame in such a way that it does not project over the cooking utensil.
This appliance is labelled
in accordance with European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.
If you encounter a problem
IIf you have any questions or if a fault occurs, please call Customer Service.
(See list of Customer Service representatives).
When you call, please quote the following:
E-Nr. FD
Enter the relevant numbers into the box above. The E-Nr. (product no.) and FD (production date) are shown on the nameplate which can be seen inside the extractor hood after the filter frame has been detached.
The manufacturer of the extractor
hoods accepts no liability for complaints which can be attributed to the design and layout of the pipework.
5
Before using for the first time
Safety instructions
Do not flambé food directly under the
extractor hood.
Risk of grease filter catching fire due
! to flames.
The hotplates must always be covered
with a utensil.
Restrictions apply to the use of the
extractor hood over a solid-fuel burner (coal, wood, etc.). (See Installation instructions).
The appliance is not intended for use
by young children or infirmed persons without supervision. Young children should be supervised to ensure they do not play with the appliance.
Light bulbs must always be fitted when
the extractor hood is in use.
Defective bulbs should be replaced
immediately to prevent the remaining bulbs from overloading.
Never operate the extractor hood
without a grease filter.
Overheated fat or oil can easily catch
fire. If you are cooking with fat or oil, e.g. chips, etc., never leave the cooker unattended.
Do not use the appliance if damaged.The appliance may be connected to
the mains by a qualified technician only.
If the connecting cable for this
appliance is damaged, the cable must be replaced by the manufacturer or his customer service or a similarly qualified person in order to prevent serious injury to the user.
Dispose of packaging materials
properly (see Installation instructions).
This extractor hood is designed for
domestic use only.
Never allow children to play with the
appliance. Do not let adults or children operate the
appliance unsupervised: – if they are mentally or physically unable
to use the appliance safely and correctly,
– if they don’t have the knowledge and
experience to use the appliance safely and correctly.
Carefully clean the extractor hood
before switching on for the first time.
Do not place any objects on the
extractor hood.
6
Operating procedure
The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished cooking.
Setting the required fan speed:
Press the corresponding button.
Lighting:
The light can be switched on at any
time, even though the fan is switched off.
Light
Fan settings
Light
Fan settings
Intensive setting:
Maximum power is obtained at the
intensive setting
P. It is only required for
short intervals.
Light
Fan settings
Intensive setting
0
123
7
Filters and maintenance
Grease filters:
Metal filters are used to trap the greasy element of the vapours that develop during cooking.
The filter mats are made from non­combustible metal.
Caution:
As the filter becomes more and more saturated with grease, not only does the risk of it catching fire increase but the efficiency of the extractor hood can also be adversely affected.
Important:
By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced.
Cleaning the metal grease filters:
In normal operation (1 to 2 hours daily),
the metal grease filter must be cleaned 1 x a month.
The filters can be cleaned in a dish-
washer. It is however possible that they will become slightly discoloured.
The filter must be placed loosely, and
NOT wedged, in the dishwasher.
Important:
Metal filters that are saturated with grease should not be washed together with other dishes etc.
When cleaning the filters by hand, soak
them in hot soapy water first of all. Do not use aggressive, acidic or caustic cleaners. Then brush the filters clean, rinse them thoroughly and leave the water to drain off.
2. Clean the filters.
3. Insert the clean filters back into the
hood.
Removing and inserting the metal grease filters:
Warning: The halogen bulbs must be
switched off and cool.
1. Press the catch on the grease filters inwards and fold the filters down. At the same time take hold of the under­side of the grease filters with your other hand.
8
Filters and maintenance
Activated carbon filter:
For neutralizing odours in recirculating mode.
Caution:
As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired.
Important:
Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting.
3. Engage the catch.
4. Insert the metal grease filters (see
"Removing and inserting the metal grease filters").
Replacing the activated carbon filter:
During normal operation (1 to 2 hours
per day) the activated carbon filters should be replaced approximately 2 x year.
A replacement filter can be obtained
from any authorized dealer (see optional accessories).
Use original filters only.
By doing so you will obtain maximum performance from your extractor hood.
Disposing of the old activated carbon filter:
There are no pollutants in the activated
carbon filters. They can therefore be disposed of as part of your normal domestic refuse.
Installation and removal: Warning: The halogen bulbs must be
switched off and cool.
1. Remove the metal-mesh filters (see "Removing and inserting the metal­mesh grease filters").
2. Insert the activated carbon filter.
Loading...
+ 16 hidden pages