Boomba Racing ST Focus Transmission Cable Bracket Bushings User Manual

FORD FOCUS ST
TRANSMISSION BUSHINGS
TOOLS REQUIRED
M8 socket wrench M7 socket wrench M12 box wrench M10 box wrench Large flat screw driver
Remove plastic vacuum hose from rubber
Remove the MAF sensor connector. adaptor on the top of valve cover (leave rubber adaptor in place).
1
1
Loosen up the hose clamps.
5
Remove the air box cover.
2
Remove the air box. Remove battery tray.
6
MATERIALS REQUIRED
None
3
Snap off the shifter cable connector.
7
Remove the battery cover.
4
Remove the shifter cables.
8
Remove the transmission shifter bracket.
9
Remove the metal sleeves and grommets from the bracket.
10
Prepare Boomba Racing transmission bushings.
11
The longer bolt holds the clutch line bracket.
12
Remove plastic vacuum hose from rubber
Fasten the bracket to the transmission. adaptor on the top of valve cover (leave
The thin bushing goes between the
rubber adaptor in place).
bracket and the transmission.
1
Thick bushing goes on the top of the
13
bracket.
Reinstall the shifter cables.
14
Snap on the shifter cable connector.
15
Reinstall the battery tray and the air box. Tighten the hose clamps. Reinstall the battery cover, the air filter and the filter cover. Reconnect the MAF sensor
16
connector.
Loading...