Racing, inc.
Racing, inc.
Www.boombaracing.com
THROTTLE BODY
INSTALLATION MANUAL
TOOLS REQUIRED
M 8 socket wrench
M10 socket wrench
M13 socket wrench
M6 Allen wrench
Flat Screwdriver
Loosen up the air intake tube clamp.
Remove the screws securing the solenoid
assembly.
1
Disconnect the solenoid hose.
5
Remove the air box cover screws and
then remove the cover.
2
Disconnect the vent hose and remove the
air box.
6
MATERIALS REQUIRED
None
Unplug the air temperature sensor and
remove intake short tube.
3
Disconnect electrical plugs and vacuum
hose.
7
Remove the screws securing air filter box
to the body.
4
Remove screws holding throttle cable
bracket.
8
Remove throttle cable.
9
Loosen up hose clamp and remove air
supply hose.
10
Remove throttle body screws. Remove
throttle body and adaptor.
11
Remove throttle position sensor and idle
motor assembly.
12
Install throttle position sensor and idle
motor assembly on Boomba throttle body.
13
Mount throttle body adaptor to the intake
manifold with provided screws. Before
installing adaptor make sure that all
sealing O-rings are seated properly in
14
their grooves.
Install throttle body with provided screws.
15
Connect throttle cable and install cable
bracket.
16
Connect air supply hose and secure it
with clamp. Connect electrical plugs.
17
Install and secure the air filter box.
18
Install the box cover. Attach the air
temperature connector harness. Connect
the solenoid hose to the vent hose. Bolt
on the solenoid assembly.
19
Loading...