
FORD FIESTA ST
SHIFTER PLATE
TOOLS REQUIRED
M7 socket wrench
M10 socket wrench
T25 Torx bit
Large flat screw driver
Remove plastic vacuum hose from rubber
Disconnect the MAF sensor.
adaptor on the top of valve cover (leave
rubber adaptor in place).
1
1
Loosen the air pipe clamp and remove the
air pipe.
5
Large flat screw drivers
Remove the air filter cover.
2
Snap off the air supply duct from the latch.
6
MATERIALS REQUIRED
None
Remove the air filter.
3
Remove the air box.
7
Remove the vent line.
4
Pry off the shifter cable from the shifter
arm with the flat head screw drivers.
8
Boomba Shifter Plate ready for
installation.
The extra hole in the bottom plate should
9
be on the same side that the pivot ball
during installation.
Slide the Boomba Shifter Plate over the
shifter arm.
10
Secure the shifter plate to the bottom
plate with provided screws. Reconnect the
shifter cable.
11
Reinstall the air supply tube, the vent line
and the air filter box. Tighten all hose
clamps and bolts. Reconnect the MAF
sensor.
12