Boomba Racing Fiesta ST Transmission Cable Bracket Bushings User Manual

FORD FIESTA ST

TRANSMISSION BUSHINGS

TOOLS REQUIRED

M7 socket wrench
M10 socket wrench
M12 socket wrench
M12 box wrench
T25 Torx bit

Remove plastic vacuum hose from rubber

Disconnect the MAF sensor.
adaptor on the top of valve cover (leave
rubber adaptor in place).

1

1

Loosen the air pipe clamp and remove the
air pipe.

5

Large flat screw drivers

Remove the air filter cover.

2

Snap off the air supply duct from the latch.

6

MATERIALS REQUIRED

None

Remove the air filter.

3

Remove the air box.

7

Remove the vent line.

4

Disconnect the battery terminals. Remove
the battery holder and remove the battery.

8

Remove the ECU cover.

9

Disconnect the ECU connectors.

10

Remove the battery tray with the ECU
attached.

11

Pry off the shifter cables from the shifter
arms with the flat head screw drivers.

12

Remove plastic vacuum hose from rubber

Pull the lock rings and remove the shifter
adaptor on the top of valve cover (leave

cables from the bracket.
rubber adaptor in place).

1

13

Remove the transmission bracket.

14

Remove the factory shifter bushings from
the bracket.

15

Boomba Transmission Bushings ready for
installation.

16

Install the transmission bracket. Install the
top bushings first. Thread the mounting
bolts a few threads into the housing.

The bushings with thicker flange go on top

17

Reinstall the battery tray with the ECU.
Connect the ECU connectors.

21

Install the side bushings.

The bushing with thicker flange goes to
the outside.

18

Install the ECU cover.

22

Secure bracket to the transmission.

19

Install the battery. Secure the battery to
the tray with the battery holder. Connect
the battery terminals.

23

Install the shifter cables to the bracket.
Connect the shifter cables to the shifter
arms.

20

Reinstall the air supply tube, the vent line
and the air filter box. Tighten all hose
clamps and bolts. Reconnect the MAF
sensor.

24