Bonide Wilt Stop Plant Protector RTU User Manual

WILT STOP

®

ready to use

WILT STOP® is natural nontoxic product derived
from the resin of pine trees.

WILT STOP® forms a soft, clear, flexible film
on treated plants. this film protects plants
from drying Out, drought, wind burn, sun scald,
winter kill, transplant shock, salt damage,
while at the same time allowing them to grow
naturally.

for use on: evergreens, trees, shrubs, turf,
flowers, vegetables, bulbs, houseplants,
transplants, and dormant and growing plants.

Apply: According to label instructions

one application lasts all season.

active ingredients: 5.0% pinene

Store and transport in an upright position.

©Bonide Products, Inc. All Rights Reserved

Bonide Products, Inc.
6301 Sutliff Road
Oriskany, NY 13424

Excessive moisture loss from plants causes severe wilting, shock or plant
death. It occurs in winter when drying winds and frozen ground deprive
plants of their natural moisture intake, when plant roots are disturbed
during transplanting, during periods of drought, or when Christmas trees
and greens are cut. WILT STOP® forms a protective coating which holds
moisture in on plant foliage reducing water loss during plant stress. WILT
STOP® forms a clear flexible film without interfering with plant growth. Only
one application per season is typically needed.

WILT STOP® can be used on deciduous trees, evergreens, shrubs, turf,
roses, flowering plants, vegetables, fruits, transplants, cut plants, indoor
plants, Christmas trees, and others.

SHAKE WELL BEFORE USING. SPRAY TOPS AND BOTTOMS OF
LEAVES, NEEDLES AND STEMS TO RUN-OFF. ALWAYS ALLOW WILT
STOP® TO DRY OUTDOORS IN DAYLIGHT, WASH SPRAYER WITH
WARM WATER AND DETERGENT AFTER EACH USE.

For spring, summer and fall transplanting, water plants thoroughly, when
possible, before spraying with WILT STOP®. Do not spray or dip roots.

Spray once each season, in the spring.

READ ENTIRE LABEL PRIOR TO USE!

INSTRUCTIONS

TRANSPLANTING

FOR DROUGHT AND WINDBURN PROTECTION