Bonide INFUSE RTS User Manual

infuse Trusted since 1926 bonide

systemic disease control lawn &

landscape ready to spray

CONTROLS: powdery mildew, dollar spot, rust, brown
patch, anthracnose, take-all patch and more!

FOR USE ON: lawns and ornamental plants such as
roses, flowers, trees and shrubs, plus listed fruit and

nuts.

stimulates growth of newly planted cool season lawns

and one quart (entire contents) treats up to 3,200 sq. ft.

broad spectrum and systemic disease
control.

Store and transport in an upright position.

EPA Est. No. 4-NY-1
EPA Reg. No. 100-952-4

Buyers Guarantee Limited to Label Claims.

Distributed by
Bonide Products, Inc.
6301 Sutliff Road
Oriskany, NY 13424

It is a violation of Federal law to use this product in a manner inconsistent with
its labeling.
Shake well before using.

When to apply: This product is highly effective when it is used at the first sign
of disease. Unless otherwise specified, treat at the first sign of disease. Reapply
as directed in “COMMENTS” until lawn shows signs of recovery. Resume
applications if disease reoccurs.
When to mow: Apply after mowing or allow sprayed lawn to completely dry
before mowing.
How to apply:
width. Spray evenly over measured area. Treat entire lawn.

CONNECT: 1) Shake well before using. 2) Connect sprayer to hose. 3) Turn
on water.
SPRAY: 1) To begin spraying, point nozzle in the direction you want to spray. 2)
Bend small plastic tab back and turn knob clockwise to “ON” position. 3) Spray
evenly over measured area. See chart on next page for “AREA TO COVER”.
FINISH: 1) To stop spraying, turn knob counter clockwise to “OFF” position.

2) Turn off water. 3) Relieve water pressure by turning knob to “ON” position
until water slows to a drip. Then, turn knob back to OFF position. 4) Disconnect
sprayer from hose.

Measure lawn. Calculate square feet by multiplying length times

HOW TO USE THE ATTACHED HOSE-END SPRAYER

DIRECTIONS FOR USE

ESTABLISHED LAWNS

LAWN DISEASES AREA TO COVER COMMENTS
CONTROLLED

Anthracnose 3,200 sq. ft. Apply every 14 days.
Brown Patch 1,600 sq. ft. Start applications in May or June before

disease occurs. Apply every 14 days.
For southern lawns, start applications
at first sign of disease in spring or fall.

Dichondra rust on
dichondra lawns 1,600 sq. ft. Apply every 21 days.

Dollar spot 3,200 sq. ft. Apply every 28 days.
Fusarium patch 1,600 sq. ft.
Grey leaf spot 3,200 sq. ft. Apply every 14 days in the summer.
Leaf spot 3,200 sq. ft. Apply every 14 days.

(melting out)
Pink patch 1,600 sq. ft. Apply every 21 days.
Powdery mildew 3,200 sq. ft. Apply every 21-28 days.
Red thread 1,600 sq. ft. Apply every 21 days.
Rust 3,200 sq. ft. Apply every 21-28 days.
Snow mold 1,600 sq. ft. Apply twice in the fall prior to snow

cover, waiting 14 days between each
application.
Stripe smut 3,200 sq. ft. Apply in fall after grass is dormant or in
early spring before grass starts to grow.

Summer patch 1,600 sq. ft.
and apply every 14 days up to 6 times.

Using one quart (32 fl. ozs.)

Apply every 28 days from fall to early spring.

Start applications in late May or early June

LAWN DISEASES AREA TO COVER COMMENTS
CONTROLLED

Take-all patch 1,600 sq. ft.

Southern lawns also need to be treated
twice in the summer (June-August).

In addition to its fungicide uses, this product can be used as a growth stimulator for
faster establishment of newly planted cool season lawns.
AMOUNT TO SPRAY for Newly Planted Cool Season Lawns: One quart (entire
contents) treats 3,200 sq. ft.

1) Follow “HOW TO USE THE ATTACHED HOSE-END SPRAYER” instructions from
page 2. 2) Spray evenly over 3,200 sq. ft.
WHEN TO APPLY: Lawn Seedlings: Apply at the 2 to 3-leaf stage of growth for faster
root development and top growth.

ORNAMENTAL PLANTS – Roses, Flowers, Shrubs and Shade Trees

When used as directed, this product is safe to plants and controls the diseases listed.
This product may injure African violets, begonias, Boston ferns, geraniums or other
unlisted plants, and it may not control unlisted diseases.

GENERAL USE PRECAUTION

Do not use fruit from treated crab apple trees for food purposes.
When to apply: This product is highly effective when it is used at the first sign of
disease. Unless otherwise specified in “SPECIAL COMMENTS”, treat at the first sign
of disease and reapply every 21 days until plant shows signs of recovery. Resume
applications if disease reoccurs.
How to apply:

1) Follow “HOW TO USE THE ATTACHED HOSE-END SPRAYER” instructions from page 2.

2) Spray thoroughly to cover all plant surfaces (upper and lower leaf surfaces, flowers,
stems and branches) including new growth.

3) Allow spray to completely dry before watering.

Using one quart (32 fl. ozs.)

ADDITIONAL USE - GROWTH STIMULATOR

Apply twice in the fall (September and October
and twice in the spring (April and May).

)

PLANTS DISEASES SPECIAL COMMENTS
CONTROLLED

Amelanchier Powdery mildew
Apple (non-bearing) Scab Start applications when leaves
start growing in the spring.
Apple (non-bearing) Rust Start applications when buds just

Apple (non-bearing) Powdery mildew Start applications in early spring.
Ash Powdery mildew
Azalea Monilinia flower blight Apply when there is 5% bloom
and again at 70% bloom.
Calendula Powdery mildew
Carnation Rust
Cherry (ornamental) Powdery mildew, Start applications in early spring.
leaf spot
Chrysanthemum Ray Blight
Crab Apple Scab Start applications when buds just
begin to break open.

begin to break open. Make 3 applications.
Powdery mildew
Crape myrtle Powdery mildew
Delphinium Powdery mildew
Dogwood Anthracnose
Douglas Fir, Needle Rust For Shasta Fir, apply in May-June
Shasta Fir before disease occurs.

Rust Start applications when buds just

begin to break open. Make 3 applications.

PLANTS DISEASES SPECIAL COMMENTS
(cont.) CONTROLLED (cont.)

(cont.)

Gomphrena Alternaria leaf spot
Hawthorn Rust
Iris Rust
Juniper Phomopsis blight
Lilac Powdery mildew
Marigold Alternaria leaf spot
Monarda Powdery mildew
Oak Leaf Spot
Phlox Powdery mildew
Pine Tip blight Start applications in mid-late winter
(November-January) and apply every
2 months up to 3 times.
Poplar Rust
Pyracantha Blight
Red tip photinia Leaf spot
Rhododendron Flower blight Apply when there is 5% bloom and
again at 70% bloom.
Roses Powdery mildew Thorough coverage is needed for
best results. Start applications when
buds just begin to break open.
Roses Black spot & rust For severe black spot on roses
alternate every 7 to 10 days
between this product and Bonide
Rose Rx Insect & Disease Control.

PLANTS DISEASES SPECIAL COMMENTS
(cont.) CONTROLLED (cont.)

Snapdragons Rust
Sweet William Leaf spot
Zinnia Powdery mildew

When used as directed, this product is safe to plants and controls the diseases listed.
GENERAL USE PRECAUTION
Do not apply to "Stanley" type plums.
When to apply: This product is highly effective when it is used at the first sign of
disease. Unless otherwise specified in “SPECIAL COMMENTS”, treat at the first sign
of disease and reapply every 21 days until plant shows signs of recovery. Resume
applications if disease reoccurs.

How to apply:

1) Apply 4 tsp. (1
nut trees. Apply spray mixture to the point just when it begins to run off the leaves.

2) Spray thoroughly to cover all plant surfaces (upper and lower leaf surfaces, flowers,
stems and branches) including new growth.

3) Allow spray to completely dry before watering.

BEARING FRUIT
AND NUT TREES

Apricots, Cherries,
Nectarines, Peaches,
Plums and Prunes

BEARING FRUIT AND NUT TREES

1/3

ounces) of product to 250 to 500 square feet of bearing fruit and

DISEASES
CONTROLLED

Brown Rot Blossom
Blight, Powdery
Mildew, Cherry
Leaf Spot and Fruit
Brown Rot

COMMENTS

Start applications in early spring and spray
every 21 days, making no more than 5
applications for the entire season. Up to 3
applications may be made from early bloom
through petal fall. Up to 2 applications
may be made from the end of petal fall
through harvest.

When used as directed, this product is safe to plants and controls the diseases listed.
When to apply: Apply when disease first appears and continue every 14 days, making
no more than 4 applications. Do not apply to sweet corn within 14 days of harvest.

How to apply:

1) Apply 4 tsp. (1

2) Spray thoroughly to cover all plant surfaces (upper and lower leaf surfaces).

3) Allow spray to completely dry before watering.

SWEET CORN

Sweet Corn

1/3

ounces) of product to 250 to 500 square feet of sweet corn.

DISEASES
CONTROLLED

Leaf Blights, Rust,
Gray Leaf Spot and
Eye Spot

SWEET CORN

COMMENTS

Apply when disease first appears and
continue every 14 days, making no more
than 4 applications. Do not apply to sweet
corn within 14 days of harvest.

If in eyes
Remove contact lenses, if present, after the first 5 minutes,
then continue rinsing eye.
Call a poison control center or doctor for treatment advice.

If swallowed

Have person sip a glass of water if able to swallow.
Do not induce vomiting unless told to do so by the poison
control center or doctor.
Do not give anything by mouth to an unconscious person.

If on skin Take off contaminated clothing.
or clothing Rinse skin immediately with plenty of water for 15-20 minutes.

Call a poison control center or doctor for treatment advice.
If inhaled Move person to fresh air.

If person is not breathing, call 911 or an ambulance, then give
artificial respiration, preferably by mouth-to-mouth, if possible.

Call a poison control center or doctor for further treatment advice.

If ingested, induce emesis or lavage stomach. Treat symptomatically.
Have the product container or label with you when calling a poison control center

or doctor, or going for treatment.

Hold eye open and rinse slowly and gently with water for 15-20 minutes.

Call a poison control center or doctor immediately for treatment advice.

For 24 Hour Medical Emergency Assistance (Human or Animal) or

Chemical Emergency Assistance (Spill, Leak, Fire, or Accident),

FIRST AID

NOTE TO PHYSICIAN

HOT LINE NUMBER

Call

1-800-858-7378

PRECAUTIONARY STATEMENTS

WARNING: Causes substantial, but temporary eye injury. Do not get in eyes. Wear

goggles or safety glasses. Harmful if swallowed, inhaled, or absorbed through
skin. Avoid contact with skin or clothing. Avoid breathing vapor or spray mist.
Wash thoroughly with soap and water after handling. Remove contaminated
clothing and wash before reuse.

ENVIRONMENTAL HAZARDS

This pesticide is toxic to fish. Do not apply directly to water. Do not contaminate
water when disposing of equipment wash water.

Do not contaminate water, food, or feed by storage or disposal.

PESTICIDE STORAGE: Store in a cool, dry place, away from heat or open flame.
PESTICIDE DISPOSAL: If empty – Do not reuse this container. Place in trash

or offer for recycling if available. If partly filled – Call your local solid waste
agency for disposal instructions. Never place unused product down any indoor
or outdoor drain.

HAZARDS TO HUMANS & DOMESTIC ANIMALS

STORAGE AND DISPOSAL

THIS PAGE INTENTIONALLY LEFT BLANK

THIS PAGE INTENTIONALLY LEFT BLANK