Power: Rechargeable battery - USB cord
Operation temperature range: 50° to 85° Fahrenheit
(10° to 30° Celsius)
CHARGING THE SCALE
1. Lift the rubber charging port cover and plug the small
end of the USB cord into the port on the scale. (FIG A)
2. Plug the larger end of the USB cord into a computer or
power adapter that is 5V 2amps or less. (FIG B)
(NOTE: Plugging the cord into an adapter greater than 5V
could cause damage to the scale or reduce battery life.)
3. When charging is complete, the battery level indicator
on the display will show a full charge.
4. When the scale is nished charging, remove cord and
replace charging port cover.
A
B
MODE SETTING
Press the MODE button to toggle through the dierent modes and units of measurement.
Once the mode and unit of measurement have been chosen, the scale will use the same
settings each time it is turned on/o until the settings are manually changed.
REG Mode – Taring and timing must be done manually.
Units of measurement:
oz - Select this mode for pour-over brewing measured in ounces.
The letter “R” will appear on the bottom left and “oz” will appear
on the bottom right of the display.
g - Select this mode for pour-over brewing measured in grams.
The letter “R” will appear on the bottom left and “g” will appear
on the top right of the display.
POUR Mode – This mode includes auto-tare and auto-timer functions.
Units of measurement:
oz - Select this mode for pour-over brewing measured in ounces.
The letter “P” will appear on the bottom left and “oz” will appear
on the bottom right of the display.
g - Select this mode for pour-over brewing measured in grams.
The letter “P” will appear on the bottom left and “g” will appear
on the top right of the display.
OPERATION
POUR Mode:
1. Place dripper and carafe or cup on scale. The timer on the left of the display will
show 0’00” and the weight on the right side of the display will automatically tare
to 0.00.
Note: This mode automatically tares the rst item set on the scale; it is necessary to
manually tare subsequent items placed on scale as indicated below.
2. Add coee grounds.
3. Tare the scale by pressing TARE once. The display will show 0.00.
4. Add water. The timer will automatically start when the scale senses the weight
beginning to change. Since the display shows the weight and time, this will allow
you to customize how you brew your coee.
REG Mode:
1. Place item on scale; the weight of the item is shown on the right side of the
display.
2. Press TARE as needed for each item added to the scale.
3. Start the timer by pressing the TIMER button. The display will ash once, and
then the timer will begin. The time is shown on the left side of the display.
4. To pause the timer, press the TIMER button once.
5. To reset the timer to 0’00”, press the TIMER button twice.
NOTE: The timer will reset to 0’00” once it reaches 9’59”.
TARE FUNCTION
Press TARE to cancel out or “zero” the weight on the scale.
Loading...
+ 12 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.