BOM Quote Science and Technology BT AS 001 01 User Manual

User Manual

Thank you very much for your favor of our products! This manual aims to enable you quickly

grasp the use of the product.

This manual applies to the following model:

BT-AS-001-01

The guide of operation

1. Powered on to enter the sleep mode.

2. Long press the key for 2 seconds to start up and release, the blue indicator light will be on for

2 seconds and then flicker into the pairing mode. After the phone is paired successfully, the

indicator light will be off.

3. Turn on the phone camera and click key to realize the camera function.

4. When power on, press key for 3 seconds to turn off, and the red indicator light will be on for

2 seconds

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.

§ 15.19 Labeling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

§ 15.21 Information to user.

Any Changes or modifications not expressly
void the user's authority to operate the equipment.

approved by the party responsible for compliance could