Bolens 110-120-306 User Manual

10 CENTS

Model Nos. 110-120-306,

110-121-306, 110-140-306,

and 110-141-306

ROTARY MOWER

For one year from date of purchase, MTD Products, Inc.,
will replace for the original purchaser, free of charge, F.O.B.
factory or authorized service firm, any part or parts found to
be defective in material or workmanship. All transportation
charges on parts submitted for replacement under this war
ranty must be paid by the purchaser. This w^ranty does not

include replacement of parts which become inoperative

through misuse, excessive use, accident, neglect, improper

maintenance or alterations by unauthorized persons. This

warranty does not include the engine, motor, battery, bat
tery charger or any component parts thereof. For service on

these units refer to the applicable manufacturer's warranty.

The above warranty will apply only to the original owner

and will be effective only if the warranty card has been pro
perly processed. It will not apply where the unit has been
used commercially.

Warranty service is available through your local author

ized service dealer or distributor. UNDER NO CIRCUM
STANCES WILL THE RETURN OF A COMPLETE UNIT

BE ACCEPTED BY THE FACTORY UNLESS PRIOR

WRITTEN PERMISSION HAS BEEN EXTENDED.

\

Your rotary mower is a precision piece of power equip

ment, not a plaything. Therefore exercise extreme caution
at all times.

1. Remove all sticks, stones, wire and other hazardous items
from lawn before mowing. Such items are dangerous to
both the mower and individuals in the vicinity of the
mower.

2. Always disconnect spark plug cable during repairs or re
fueling operations.

3. Always start engine from side opposite discharge chute.

4. NEVER place hands or feet under mower or near dis
charge chute while engine is running.

5. Do not tilt mower at extreme angle while engine is run
ning. Cut grass on hills and banks sideways, not up and
down.

6. Always stop engine when not cutting grass.

7. Do not fill gas tank while engine is running. Do not spill
gasoline on hot engine.

8. Keep children and pets away from area at all times during
mowing operation. Never allow mower to discharge grass
toward any person.

9. Do not attempt to start engine while mower is resting in

high grass.

10. Check all nuts and bolts, particularly the blade bolts, for

tightness. This is especially important during the initial
operation period. Make this same check periodically
thereafter.

11. While operating the mower, if any foreign object is struck,

stop the mower and inspect for damage. Do not restart
or operate the mower until all damage has been repaired.

WARNING: Should excessive vibration develop, check your
blade and crankshaft immediately. Do not operate mower
with an unbalanced blade, a damaged blade or a damaged
crankshaft.

MTD FRODDCTS IKTC

• 5389 west i30th st. • p.o. box 274i • Cleveland, ohio 44in

FORM NO. 770-2801A

Hairpin Handle

on

110-120-306

110-140-306

Folding Handle

on

110-121-306
110-141-306

When ordering parts give
the following information:

1. Model number

2. Part number

3. Part name

4. Color of part

CHANGE OIL
Change oil after first 5 hours of

operation while engine is warm.
Thereafter, change oil every 25
hours of operation while engine is
warm. Engine may be drained
through oil filler opening. Be sure
to replace droin plug and oil filler
cap.

ASSEMBLY INSTRUCTIONS

110-121 « 110-141

FORM NO. 770-2801B

—18 ^

NOTE: Before operating your mower, check
oil nuts and bolts for proper tightness. Be
sure to check the Blade Bolt.

NOTE: Use caution in folding handles to

prevent damage to
Control Knobs and
Wires.