Bogen RPK84 Service Manual
PC
M
CPU
PC
M
ZPM
TIM
PC
M
.......................
......................
....................
....................
......................
..................
RACK MOUNTING
SCREWS ARE NOT
SUPPLIED
RACK MOUNTING
A 4 MODULE ASSEMBLY
A
B
D
C
F
E
PCM
ZPM
Model: RPK84
PCM
CPU
P
CM
ZPM
TIM
PC
M
.......................
......................
....................
....................
......................
..................
RACK MOUNTING
SCREWS ARE NOT
SUPPLIED
RACK MOUNTING
A 4 MODULE ASSEMBLY
A
B
D
C
F
E
PC
M
ZPM
PCM2000
Rack Mounting Kit
Rack Mounting A Typical
4-Module Assembly
Installation
1. Position the left side of the completed PCM assembly over one of the rack mounting
adapters. Refer to the figure above and the table below to determine the correct
holes for the number of modules in the assembly.
Total Modules 2 3 4 5 6
Mounting Holes C & D B & D B & E B & F A & F
2. Secure the left side of the PCM system to the rack adapter using two of the truss
head sheet metal screws included with the kit.
3. Secure the right side of the PCM system to the other rack adapter using the holes
for the number of modules in the assembly and the remaining two truss head sheet
metal screws.
4. Secure the assembly to a 19" rack (rack screws not supplied).
Specifications subject to change without notice.
© 2000 Bogen Communications, Inc.
Part No. 54-2032-01R3 Printed in Korea. 0203
50 Spring Street, Ramsey, New Jersey 07446
Tel. 201-934-8500, Fax: 201-934-9832
www.bogen.com
Loading...