OXC1Sync Charger
© 2012 Bogen Communications, Inc.
54-2208-01A 1204
Specifications subject to change without notice.
S
YNC CHARGER
S
YNC
C
HARGE R
SYNC
CHARG ER
External Sync Charger for OMX1 MIC/Transmitters
Charging OMX1 MIC/Transmitter Units
Begin by connecting the included Power Supply into the DC Power Connector on
the OXC1, plug the power supply into an AC outlet, and set the bottom Frequency
Band switch. The OMX1 MIC/Transmitter units are inserted into the OXC1 Sync
Charger as shown. A MIC/Transmitter using the “A” Channel should only be
inserted in the “A” charging dock in the OXC1, a “B” Channel MIC/Transmitter only
into the “B” dock. The OXC1 syncs the transmittersʼ operating frequencies to the
Orator base unit, depending on the setting of the bottom switch. A mechanical
“click” is noticeable when the OMX1 is fully inserted into the OXC1 dock. When
an OMX1 has been inserted, the OXC1 charge indicator will illuminate. The Orator
manual contains more information regarding charging bays and charge dock
selection tabs.
Charging Dock Indicators
Charge
When an OMX1 is being charged, the OXC1
charge indicator will illuminate GREEN.
Charging is complete when the indicator is
extinguished.
Fault
A fault condition will be signaled by a RED
indicator, and may indicate a problem with
the OMX1 battery.
MIC/Transmitter Accessory Storage Area
Charge
Indicators
Charging
Dock
OXC1
SIDE
VIEW
SYNC
CHARGER
S
YNC
C
H
ARGER
Insert OMX1
MIC/Transmitters
into OXC1 Docks
LED Indicators
A
B
B
Charging
Dock
A
SYNC
CHARG ER
Loading...