Bogen MCD1X2UGRILLE User Manual

MCD1X2UGRILLE

Speaker Module & Ceiling Grille Assembly

11-1/2”

TILE BRIDGE

MCD1X2U

PERFORATED

35-1/2”

CEILING TILE

2 x 2

2 ft. x 2 ft.

CEILING

GRID

2 x 4

2 ft. x 4 ft.

CEILING

GRID

CEILING

TILE

(Cut to

2 ft. x 11-1/2 in.)

(Cut to 2 ft. x 35-1/2 in.)

GRILLE

SPEAKER

HOLES

SPEAKER HOLES

TO BE SITUATED

IN CORNER OF

CEILING GRID

TILE BRIDGE

Ceiling Grille Installation

1. For a 2’ x 2’ ceiling tile space opening, remove the existing ceiling tile and cut the tile to 11-1/2” long.

2. Place the MCD1X2UGRILLE into ceiling opening, making sure the corner with perforated speaker holes is situated on corner of existing ceiling grid.

3. Place the supplied Tile Bridge onto the ceiling grid and slide to the center, allowing MCD1X2UGRILLE to rest upon the Tile Bridge lip.

4. Re-install the cut ceiling tile back onto the ceiling grid and Tile Bridge lip.

5. For a 2’ x 4’ ceiling tile space opening, remove the existing tile and cut the tile to 35-1/2” long. Then follow steps 2 thru 4 to position ceiling speaker.

SPEAKER HOLES

TO BE SITUATED

MCD1X2U

GRILLE

PERFORATED

SPEAKER

HOLES

IN CORNER OF

CEILING GRID

MODULE

CLIP

MODULE CLIP

TILE BRIDGE

SUPPORT RAIL

CROSSBAR

GRILLE

SLOTS

MCD1X2UGRILLE

PERFORATED

SPEAKER HOLES

MCDMOD

MODULE

TABS

MODULE TABS

SLIDE INTO

GRILLE SLOTS

FASTENS DOWN

ONTO GRILLE EDGE

MCMOD/MCD1X2UGRILLE Assembly Installation

To assemble the MCDMOD Speaker onto the MCD1X2UGRILLE, position the MCDMOD Speaker over the portion of the Grille with the perforated speaker holes. On the MCDMOD there are two Tabs and a Module Clip. The MCD1X2UGRILLE has two horizontal Grille Slots located on one side of the grille edge. Install the MCDMOD Speaker on a slight angle and slide the Module Tabs into the Grille Slots . These Tabs should go through completely so the MCDMOD is right up against grille edge. Then lower the MCDMOD down onto the grille surface, and while doing this the Module Clip should clamp down onto the grille edge , securing the MCDMOD flat and flush on to the MCD1X2UGRILLE.

2-YEAR WARRANTY

The

MCD1X2UGRILLE

material & workmanship for two (2) years from the date of sale to the original purchaser. This warranty does not extend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have been modified or repaired or altered in any manner whatsoever, or where serial number or date code has been removed or defaced.

is warranted to be free from defects in

www.bogen.com

Specifications subject to change without notice.