Bogen LUAMFMT User Manual

Digital AM / FM Tuner

Installation and Use Manual

54-2000-01 9910

PEC Code: 5335-505

COM Code: 408184257

Model: LUAMFMT

Select Code: 701-000-105

Issue 1, October 1999

Notice

Every effort was made to ensure that the information in this guide was complete and accurate at the time of printing. However, information is subject to change.

FCC Statement (Part 15) - Radio Frequency Interference

The Digital AM/FM Tuner generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. Testing is being conducted for compliance with the limits for a Class B device in accordance with the specifications in Part 15 of the FCC Rules and Canadian D.O.C. regulations. This testing is designed to provide reasonable protection against such interference. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the Digital AM/FM Tuner unit off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient the radio or TV receiving antenna.

- Relocate the Digital AM/FM Tuner unit with respect to the radio or TV receiver or vice-versa.

- Plug the Digital AM/FM Tuner unit into a different outlet so that it and the radio or TV receiver are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user may find the following booklet, "How To Identify and Resolve Radio-TV Interference Problems," helpful. This booklet was prepared by the Federal Communications Commission (FCC) and is available from the U.S. Government Printing Office, Washington, DC 20402. Stock order No. 004-000-00345-4.

Important Safety Information

Always follow these basic safety precautions when installing and using the unit:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. DO NOT block or cover the ventilation slots and openings. They prevent the product from overheating. DO NOT place the product in a separate enclosure or cabinet, unless proper ventilation is provided.

4. Never spill liquid on the product or drop objects into the ventilation slots and openings. Doing so may result in serious damage to the components.

5. Repair or service must be performed by a factory authorized repair facility.

6. The product is provided with a UL-CSA approved, 3wire ground type plug. This is a safety feature. DO NOT defeat the safety purpose of the grounding type plug. DO NOT staple or otherwise attach the AC power supply cord to building surfaces.

7. DO NOT use the product near water or in a wet or damp place (such as a wet basement).

8. DO NOT use extension cords. The product must be installed within 6 feet of a grounded outlet receptacle.

9. DO NOT install telephone wiring during a lightning storm.

10. DO NOT install telephone jacks in a wet location unless the jack is specifically designed for wet locations.

11. Never touch uninsulated wires or terminals, unless the line has been disconnected at the paging or controller interface.

12. Use caution when installing or modifying paging or control lines.

Support Information

Paging systems integrated with small phone systems such as Merlin Legend and Partner are supported by the National Service Assistance Center (NSAC). The main number for the NSAC is 800-628-2888. Paging systems integrated with large switches such as the DEFINITY G3 are supported by the Technical Service Center (TSC). The main number for the TSC is 800-242-2121.

Domestic and International Approvals

UL Listed 538C; FCC Part 15.

Page 2 of 4

+ 2 hidden pages