Bogen HS30EZ User Manual

Easy Design Speaker
Model HS30EZ

TM

Speaker Layout

The layout of the speakers should be planned prior
to installation. Desired mounting height, barring
obstructions, is 15 to 20 feet, with the speakers
angled downward toward the listening area and
facing in the same direction.

Layout starts in one corner of the area.The first
speaker in Row 1 should be positioned 45 feet
from the corner.The next speaker in Row 1 should
be 90 feet from the first speaker (see Figure 1).
Each additional speaker in the row should use this
same spacing.

Row 2 starts 55 feet from Row 1 and, like Row 1,
each speaker in Row 2 should be 90 feet apart.

Row 3 starts 55 feet from Row 2. Continue this
pattern of alternating rows until the area is cov­ered.

For areas that include high shelving or corridors,
speakers should be installed so that they project
down the aisles between the shelves or down
through the corridors.

The spacing of the speakers can be adjusted so
that the speakers are evenly spaced in a row.

NO

TE: Each environment is unique.This layout
plan is general in nature and may not be
applicable for every installation.

Figure 1

START

HORN SPEAKER

A

B

C

Row 1

Row 2

Row 3

Row 4

Figure 2

Specifications subject to change without notice.
© 1999 Bogen Communications Inc. All rights reserved.
54-5073-01 Printed in Korea 9906

45 ft. 90 ft. 55 ft. Full Clockwise

Very High Noise
(85dB-95dB)

A B C Volume Setting

PLACEMENT

50 Spring Street, Ramsey NJ 07446

Tel. [phone], Fax: [phone]

www.bogen.com

Speaker Installation

STEP 1 - For easier installation, remove the flange (base)
from the speaker by unscrewing the wing nut while at the
same time pressing inwardly on the wing nut. Place the flange
flush with the mounting surface and mark the location of the
three holes with either a marker or chisel. It is important that
the three holes be exactly aligned with the flange, otherwise
you might stress the base or make the connection unsteady.
Drill the necessary holes and screw the flange to the surface
(see Figure 3). (Use appropriate hardware for your specific
mounting surface.)

NO

TE: The speaker may also be strap-mounted using

standard 1/2-inch industrial strapping.

STEP 2 - After mounting the flange, reattach the speaker to
the flange and aim the speaker for the desired coverage. A 45
downward angle is recommended, but this may vary depend­ing upon speaker layout and floor plan.

STEP 3 - Remove the plastic cover to make the electrical
connection and set the volume control (see Figure 4).The sug­gested amplifier connections are:

Amplifier Outputs Speaker Connections

70V Terminal 1
COM Terminal 2

NO

TE: The speaker will also work perfectly well with these
connections reversed. However, it is important to be
consistent in the wiring of the speakers in the system.

STEP 4 - Adjust the volume control to the desired setting.
See Figure 2 for the suggested initial settings based on the
ambient noise level of the environment. Place the protective
cover back over the exposed area.

NO

TE:The two furthermost clockwise settings on the volume
control will produce the same volume.

Figure 3

Figure 4

ELECTRICAL
CONNECTION

VOLUME
CONTROL

o