Bogen HFCS1 User Manual

High-Fidelity
Ceiling Speaker

HFCS1

Installation and Use Manual

© 2003 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.

54-2091-01B 0406

Product Description

Thank you for choosing Bogen’s High-Fidelity Ceiling Loudspeaker. Please familiarize
yourself with this product by reading and reviewing the descriptions and diagrams in
this manual.

Bogen’s coaxial 2-way hi-fi ceiling speakers deliver unsurpassed performance and
value.A large steel back can and dual front exit ports allow for deep bass response,
enhancing the quality and intelligibility of both speech and music.

The Bogen HFCS1 can be installed in either suspended ceiling structures or hard

surfaces such as sheetrock. It comes ready to install with integral swinging arm
clamps. An optional mounting bracket (TBCR) is available for additional support
(recommended for all suspended ceiling applications).The bracket can also be used
for new construction ceilings, providing a cutout guide behind the sheetrock surface
and as a C-ring to stiffen the edges of the cutout opening.

A variety of speaker power levels are easily selected via a front panel rotary switch.

Settings for both 70V and 100V high-impedance systems, as well as a low-impedance
(16-ohm) position, are provided.

The HFCS1 features a removable snap-lock input connector, providing easy wire

connection for input as well as loop-through to the next speaker.

IMPORTANT

The HFCS1 is not an outdoor speaker. Do not expose the speaker to rain or
moisture.The HFCS1 should be installed by qualified personnel.

Product Diagrams

HFCS1 Front Drawing (grille removed)

1. Coaxial Driver Assembly

2. Dual Bass Tuning Vents (x2)

3. Grille Retention Groove

4. Power Tap Selection Switch

5. Mounting Clamp Screws (x4)

HFCS1 Rear Drawing

6. Metal Back Can

7. Snap-Lock Input Connector

HFCS1 Front Drawing

(grille removed)

8. Mounting Clamps (x4)

HFCS1 Rear Drawing (terminal cover)

9.Terminal Covers (2 identical halves)

10. Eyelets (x2)

11. Mounting Screws (x4)

12.Wire Exit Slot

13. Conduit Knockout (x2)

HFCS1 Rear Drawing

HFCS1 Rear Drawing

(terminal cover)

1