JX540
INDEX
1. OVERVIEW DRAWING....................錯誤! 尚未定義書籤。
2. IMPORTANT SAFETY INSTRUCTIONS.............................. 3
3. GROUNDING INSTRUCTIONS............................................ 4
4. PRE-ASSEMBLY CHECK LIST............................................. 6
5. ASSEMBLY STEPS................................................................. 7
6. CAUTION...........................................錯誤! 尚未定義書籤。
7. MAINTENANCE....................................................................11
8. COMPUTER OPERATION INSTRUCTIONS..................... 12
1. OVERVIEW DRAWING
安全插銷
電子表
電源開關
過載保護開關
手握心跳
車台
後調整盒
Safety Key
Computer
Power Cord
Power Switch
Circuit Breaker
Frame
Grip Pulse Sensor
Rear End Cap
2. IMPORTANT SAFETY INSTRUCTION
When using this product, basic precautions should always be followed, including the
following:
Please read the instruction carefully before starting to use this product.
Danger – To reduce the risk of electric shock：
1. Always unplug this product from the electrical outlet immediately after using
and before cleaning the treadmill.
Warning – To reduce the risk of burn, fire, electric shock, or physical injury：
1. The product should never be left unattended while plugged in. Unplug the
product from the outlet before taking on or off the clothes and other belongings.
2. To avoid any danger, close supervision is necessary when this product is used by
children, invalids, or disabled persons. So it is when the machine is working with
such persons around.
3. Be sure to use the product only for its intended use as described in this manual.
Do not use any attachment not recommended by the manufacturer in order to
avoid any danger or accidents.
4. Never operate the product if it has a damaged cord or plug, is not working
properly, damaged, or dropped into water. Please return the product to the service
center of seller for examination and repair.
5. Do not carry this product by the power cord or use the cord as a handle.
6. Keep the cord away from hot surfaces or ground.
7. Never operate the product with the air vents on the treadmill blocked. Keep the
air vents free of lint, hair, etc.
8. Never drop or insert any objects into any went of the treadmill.
9. Do not use or operate outdoors.
10. Do not operate where aerosol (spray) products are being used or where oxygen is
thin.
11. Before turning the product off, turn all switches to the off position then remove
the plug from the outlet.
12. Connect the product to a properly grounded outlet only.
13. This machine is intended for household use only.
14. If the power cord is damaged, be sure to ask the manufacturer for replacement to
avoid accidents.
3.GROUNDING INSTRUCTION
This product must be grounded. If the treadmill should be malfunction or breakdown,
grounding provides a path of least resistance for electric current to reduce the risk of
electric shock.
This product contains a power cord with a grounding conductor and a grounding plug.
The plug must be plugged into a correct outlet that is properly installed and grounded.
Danger— Improper connection of the grounding conductor can result in a risk of
electric shock. Check with a professional electrician or serviceman if you doubt
whether the product is properly grounded. If the grounding plug enclosed in the
product doesn’t fit the outlet, have a proper outlet installed by a qualified electrician.
This product is for use on a normal 220V~240V circuit and contains a plug that looks
like the one illustrated in the drawing. Make sure that the product is connected to an
outlet with the same configuration as the plug.
No adapter should be used with the product.
Drawing
Grounding methods
GROUNDED
OUTLET
4. PRE-ASSEMBLY CHECK LIST
A
B
C
D
E
F
ITEM Description Qty
A
Computer Console
1
B
Frame
1
C
Upright (L)
1
D Upright (R) 1
E
Decoration Cover (L)
1
F
Decoration Cover (R)
1
G
H
J
K
ITEM Description Qty
a Allen Bolt M8xP1.25x15 10
b Allen Bolt M8xP1.25x60、（SAEK299） 4
c ScrewM5xP0.8x15 4
d Bottle 1
e Hex Wrench 6mm（80mmx80mm） 1
f Hex Wrench& Screwdriver 5mm(70mmx70mm) 1
g Safety Key/Clip 1
h SILICON 1
i Power Cord 1
j Bottle Holder 2
k MP3 Connector 1
l Chest Band Transmitter 1
m
n
a
b
e
c
f
g
h
i
d
j
k
l
5. ASSEMBLY STEPS
Two persons are required to finish the
assembly steps.
(Caution!! Please follow exactly the
assembly steps below to avoid injury. )
1. Pull out Control Wire with Guide
Thread in right Upright (D). After
inserting left and right Uprights (C,
D) to the proper place, tighten with
Allen Bolt (a).
Ps.1. To avoid unexpected accident,
always assemble the treadmill with
an assistant, do not assemble by
oneself.
Ps.2. When assembling the Upright, one
person should hold the Upright to
prevent it from falling.
C
D
a
2. After Uprights are tightened, cap
left and right Decoration Covers (E,
F) to the Frame and tighten them
with Screw (c) according to the
right drawing.
c
F
E
3. To assemble the Computer：
According to the right drawing:
Connect control wires between left
and right Uprights and the
Computer. Then assemble left and
right Uprights （C, D） and
Computer Console (A) with Allen
Bolt (b).
A
C
D
b
4. Wedge the bottle holder (j) into the
computer according to the right
drawing.
j
j
6. CAUTION
Note: The Cylinder is made of high pressure.
Please avoid crash with any objective.
Note: If the cylinder were damaged, the frame
would not be stable and may cause serious
danger while folded up.
This treadmill have the foldable mechanism for
storage, Stop all movement (include treadmill
belt stop, take off the power cord) before storage,
then fold the main frame as the direction shown
in the picture. Be sure the fixing plate inserts the
tube of base frame. Opposite, if you want to use
treadmill，step on the fixing plate as the
direction. When it disjoins from tube of base
frame, be careful to pull down the main frame.
Please stands beside the treadmill and the main
frame will be slowly to the ground automatically.
(Ps.1. To prevent from causing danger, be
careful if the kids are around. If want to
move the treadmill, must fold the treadmill,
let hands hold on rear adjust box, then make
the treadmill incline until the roller can be
moved smoothly, then you can move the
treadmill.)
(Ps.2. DO NOT move the treadmill on uneven
ground.)
(Ps.3. To avoid the injury, do not stand under
the frame when the frame is descending.)
Loading...