BodyMedia BMSWWGPOTS Users Manual

Wireless Gateway for Analog Telephones

Instructions

To Setup

1. Locate the SenseWear® Wireless Gateway near a telephone jack and
electrical outlet.

2. Plug the power adapter into the Wireless Gateway and into the electrical
outlet.

3. Plug the telephone cable between one of the PHONE jacks on the Wireless
Gateway and your home telephone jack.

4. If desired, you may plug a telephone into the free PHONE jack on the
Wireless Gateway.

Rev 1 – Dec 04

Operating Instructions

1. Take a reading using a SenseWear® Biometric Transceiver enabled device.

2. The RECEIVE light will blink when readings are received.

3. A tone can be heard when valid readings are accepted by the Wireless
Gateway.

4. The POWER light will blink when the Wireless Gateway is using the phone line
to upload your data to your monitoring service.

5. If it is unable to upload your data, it will retry periodically until successful.

6. If the ERROR light turns on, please contact technical support for assistance.

Notes

To maximize transceiver reception range, avoid placing anything on top of the
Wireless Gateway.

To power off the Wireless Gateway, simply unplug the power adapter from the wall.

Rev 1 – Dec 04