Bobrick Washroom Equipment, Inc. 10 28 00 Toilet & Bath KKCAP Product Specification – 12/8/09
MASTER FORMAT 2004 SECTION 10 28 00 MASTER FORMAT 1995 SECTION 10800
TOILET & BATH ACCESSORIES
Baby Changing Station, Child Protection Seat
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Vertical or Horizontal Baby Changing Stations and Child Protection Seat for use
in commercial men's and women's toilet and bath facilities.
1.02 QUALITY ASSURANCE
A. Unit shall have Microban® antimicrobial embedded into plastic material on the
changing surface. Unit shall conform to ANSI S117.1 Accessible and Usable
Building and Facilities, ASTM F 2285-04 Standard Safety Performance Specification
for diaper changing Tables for Commercial Use, ANSI Z535.4 Product Safety Signs
and Labels, EN 12221-1:2008, ASTM G22 Antibacterial standards or local code if
more stringent installation requirements are applicable for Barrier-Free accessibility.
1.03 WARRANTY
A. Submit manufacturer’s 5-year limited warranty on materials and workmanship and 5
year replacement warranty against vandalism agreeing to repair or replace unit that
fails to perform as intended from date of substantial completion.
PART 2 PRODUCTS
2.01 MANUFACTURERS
A. Acceptable Manufacturers: Koala Kare Products, a Division of Bobrick,
Centennial, CO, 888-733-3456
2.02 ACCEPTABLE PRODUCTS
A. Baby Changing Stations
1. Horizontal Design (Model KB200-00)
2. Vertical Design with molded Braille instructions (Model KB101-00)
3. Stainless Steel Recessed Mounted Horizontal Design (Model KB110-SSRE)
4. Stainless Steel Surface Mounted Horizontal Design (Model KB110-SSWM)
Page 1 of 2
Bobrick Washroom Equipment, Inc. 10 28 00 Toilet & Bath KKCAP Product Specification – 12/8/09
B. Sanitary Liner Refills. Liners are for use with all Koala Baby Changing Station
designs (Model KB150-99).
C. Child Protection Seat: Koala Child Protection Seat (Model KB102-00)
2.03 MATERIALS
A. Materials/finishes: {[Molded FDA approved high density polypropylene HDPE,
cream color] (Models KB200-00, KB101-00, KB102-00)]} {[18 gauge, type 304
satin stainless steel exterior finish with grey polyethylene interior (Models KB110-
SSRE, KB110SSWM)]}.
B. Hinges: reinforced, full-length steel-on-steel. (KB200-00 Unibody steel Chassis)
C. Mounting supports: multiple, 11-gauge steel.
D. Operation: hidden pneumatic gas spring mechanism for safe open/close motions.
2.04 ACCESSORIES
A. Integral, built-in Liner Dispenser for use with 3-ply chemical-free biodegradable 13"
x 19" sanitary liners.
B. Replaceable snap-lock protective holding straps.
C. Molded graphic instructions and safety messages in 4 languages and
Optional Braille label available. Identifying door plaque.
D. Optional antimicrobial polyethylene.
E. Optional lock supplied with 2 keys (not available for stainless steel exterior
finish models).
PART 3 EXECUTION
3.01 PREPARATION
A. Provide templates and rough-in measurements as required.
3.02 INSTALLATION
A. Install in accordance with manufacturer's hardware and instructions.
B. Locate products to eliminate interference with door swings or use of fixtures
in compliance with ADA regulations
10 28 00 Toilet & Bath KKCAP 3-Part Specification Revised 10/10/05
Page 2 of 2
Loading...