
Technical Data
S
S
Finish Face of Wall
Concealed Wall Plate
Setscrew
24''
610mm
26''
660mm
2''
50mm
Typ.
1/2''
13mm
5-3/4''
145mm
surface-Mounted
stainless steel sHelf
B-683
Materials:
Flanges and Support Arms (2) — 18-8 S, type-304, 22-gauge (0.8mm) stainless steel. Each flange has a concealed, 16-gauge
(1.6mm) stainless steel mounting bracket. All-welded construction. Secured to wall plates with stainless steel setscrews.
Concealed Wall Plates (2) — 18-8 S, type-304, 16-gauge (1.6mm) stainless steel.
Shelf — 18-8 S, type-304, 22-gauge (0.8mm) stainless steel with roll-formed edges.
installation:
To remove concealed wall plates from back of flanges and mounting brackets, loosen setscrews. Mount each wall plate so
prongs are at top; secure with sheet-metal screws, furnished by manufacturer, at points indicated by an S. Engage mounting
brackets onto prongs of wall plates, then secure into position by tightening setscrews at bottom of flanges.
Note: Center-to-center of concealed wall plates must be within 1/16" (1.6mm) of the bar length dimension.
For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure unit with
sheet-metal screws furnished. For other wall sur faces, provide fiber plugs or expansion shields for use with sheet-metal screws
furnished, or provide 1/8" (3mm) toggle bolts or expansion bolts.
specification:
Surface-mounted shelf shall be type-304 stainless steel with bright polished finish. Flanges and suppor t arms shall be 22 gauge
(0.8mm) and equipped with concealed, 16-gauge (1.6mm) mounting brackets that are secured to concealed, 16-gauge (1.6mm)
wall plates with stainless steel setscrews. Shelf shall be 22 gauge (0.8mm) with roll-formed edges. Manufacturer's ser vice and
parts manual shall be provided to the building owner/manager upon completion of project.
Surface-Mounted Stainless Steel Shelf shall be Model B-683 of Bobrick Washroom Equipment, Inc., Clifton Park,
New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company, Scarborough,
Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited, United
Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 5/06 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2006 by Bobrick Washroom Equipment, Inc.