3-1/16''
80mm
1/2''
13mm
Finish Face of Wall
S
S
6-1/2''
165mm
Concealed
Wall Plate
Setscrew
2''
50mm
Typ.
1''
25mm
Recommended Mounting Height
Off Floor for Barrier-Free Design
38'' to 40'' 965-1015mm
surface-mounted
B-682
Technical Data
Specify Model Required:
hat and coat hook
Model B-682 Bright polished stainless steel
Model B-6827 Satin-finish stainless steel
B-6827
materials:
Flange and Support Arm — 18-8 S, type-304, 22-gauge (0.8mm) stainless steel. Concealed, 16-gauge (1.6mm) stainless steel
mounting bracket. All-welded construction. Secured to wall plate with a stainless steel setscrew.
Concealed Wall Plate — 18-8 S, type-304, 16-gauge (1.6mm) stainless steel.
Hook — 18-8 S, type-304, 12-gauge (2.8mm) stainless steel. Welded to the support arm.
installation:
To remove concealed wall plate from back of flange and mounting bracket, loosen setscrew. Mount wall plate so prongs are at
top; secure with two sheet-metal screws, furnished by manufacturer, at points indicated by an S. Engage mounting bracket onto
prongs of wall plate, then secure into position by tightening setscrew at bottom of flange.
For partitions with par ticle-board or other solid core, secure with sheet-metal screws furnished, or provide through-bolts, nuts,
and washers.
For hollow-core metal partitions, provide solid backing into which the furnished sheet-metal screws can be secured.
For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure unit with
sheet-metal screws furnished.
For other wall surfaces, provide fiber plugs or expansion shields for use with sheet-metal screws furnished, or provide 1/8"
(3mm) toggle bolts or expansion bolts.
specification:
Surface-mounted hat and coat hook shall be type-304 stainless steel with __________ (inser t one: bright polished or satin)
finish. Flange and support arm shall be 22 gauge (0.8mm) and equipped with a concealed, 16-gauge (1.6mm) mounting bracket
that is secured to a concealed, 16-gauge (1.6mm) wall plate with a stainless steel setscrew. Hook shall be 12 gauge (2.8mm),
welded to the support arm. Manufacturer's service and parts manual shall be provided to the building owner/manager upon
request.
Surface-Mounted Hat And Coat Hook shall be Model ________ (inser t model number) of Bobrick Washroom
Equipment, Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom
Equipment Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick
Washroom Equipment Limited, United Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 6/06 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2006 by Bobrick Washroom Equipment, Inc.
Loading...