Technical Data
BOBRICK
FULL
REFILL
5''
127mm
5/16''
8mm
11-5/16''
285mm
S
S
4-7/8''
125mm
Finish Face of Wall
Cap for
Top Filling
Container
Push
Button
Valve
12-13/16''
325mm
3-13/16''
95mm
S
5-1/4”''
135mm
S
7-11/16''
195mm
S
1-1/8''
30mm
Recommended Mounting Height Off Floor
For Universal / Barrier-Free Design
54-3/4'' 1390mm
LARGE-CAPACITY
SOAP DISPENSER FOR
LIQUID AND LOTION SOAPS,
AND DETERGENTS
B-60
MATERIALS:
Valve — Black molded plastic push button. Soap head-holding mushroom valve. Stainless steel spring. U-packing seal and duckbill. Antibacterial-soap-resistant plastic cylinder.
Container — Translucent, shatter-resistant polyethylene. Equipped with impact-resistant polypropylene cap for top filling.
Capacity: 1.5-gal. (5.7-L).
OPERATION:
Corrosion-resistant valve dispenses commercially marketed all-purpose hand soaps. To prevent corrosion, use only chloridefree pH-netural liquid soaps. Valve operates with one hand, without tight grasping, pinching, or twisting of the wrist and with
less than 5 pounds of force (22.2 N) to comply with barrier-free accessibility guidelines (including ADAAG in U.S.A.). Largecapacity, translucent container provides visible soap level. To fill container, unscrew and remove the large cap.
INSTALLATION:
Mount dispenser on wall with three sheet-metal screws, furnished by manufacturer, at points indicated by an S. Rubber washer
must be used inside container to seal top mounting hole. For plaster or dry wall construction, provide concealed backing to
comply with local building codes, then secure unit with sheet-metal screws. For other wall surfaces, provide fiber plugs or
expansion shields for use with sheet-metal screws, or provide 1/8" (3mm) toggle bolts or expansion bolts.
Note: Provide 4" (102mm) minimum clearance from cap to underside of any horizontal projection. Push buttons should be
located 44" (1120mm) maximum above the finish floor.
SPECIFICATION:
Container shall be translucent, shatter-resistant polyethylene with a capacity of 1.5-gal. (5.7-L) and furnished with a large cap for
top filling. Corrosion-resistant valve shall dispense commercially marketed all-purpose hand soaps. To prevent corrosion, use
only chloride-free pH-netural liquid soaps. Valve operates with one hand and with less than 5 pounds of force (22.2 N) to comply
with barrier-free accessibility guidelines (including ADAAG in U.S.A.).
Soap Dispenser shall be Model B-60 of Bobrick Washroom Equipment, Inc., Clifton Park, New York; Jackson,
Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company, Scarborough, Ontario; Bobrick Washroom
Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited, United Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 11/09 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2009 by Bobrick Washroom Equipment, Inc.
Loading...