Technical Data
280mm
Automatic Hand Dryer: 220-240V AC,
7 Amp, 1500-1700 Watts, 50/60 Hz,
Single Phase, VDE approved, CE marked
and CCC approved.
TrimLineSeries™
RECESSED PAPER TOWEL
DISPENSER, AUTOMATIC HAND
DRYER, AND WASTE RECEPTACLE
(3-IN-1 UNIT)
10-13/16''
385mm
15-1/8''
S S
10-15/16''
280mm
275mm
S
S
10-15/16''
7-7/8''
200mm
BOBRICK
AUTOMATIC HAND DRYER
8-13/16''
225mm
Finish Face of Wall
S
S
1-7/16''
35mm
3/4''
19mm
Diameter Hole for
Between-Wall Wiring
5''
125mm
Wire Opening
1-1/16''
25mm
50mm
1-7/8''
Typ.
B-38033
Finish Face of Wall
Cover
5-3/16''
130mm
5/8'' x 9/16''
16 x 14mm
Opening for Surface Wiring
S
Mounting Base
S
S
4-1/2''
115mm
S
1-7/16''
35mm
8-1/16''
205mm
Typ.
55-3/4''
1415mm
Paper
Towel
Dispenser
Shelf
Hand Dryer
990mm
39-1/16''
Typ.
Hand Dryer
Graphics
(on door)
S
Lock & Key
Typ.
89mm
3-1/2''
Typ.
1220mm
48''
Maximum
Mounting
Height
(Refer to ADA H/C)
Air Deflector
Removable
Waste
Container
14mm
9/16''
145mm
5-5/8''
1905 to 2160mm 75'' to 85''
S
Recommended Mounting Height Off Floor
1365mm
53-13/16''
S
Rough Wall Opening
322mm
12-11/16''
25mm
1''
Typ.
AUTOMATIC
HAND DRYER
S
S S
333mm
13-1/8''
Finish Face of Floor
352mm (13-7/8") wide
1385mm (54-9/16") high
MATERIALS:
145mm (5-3/4") minimum
recessed depth
Cabinet — 18-8 S, type-304, heavy-gauge stainless steel. All-welded construc tion.
Door — 18-8 S, type-304, 1.2mm (18-gauge) stainless steel. 14mm (9/16") 90° return for maximum rigidity. Secured to cabinet with a
concealed, full-length stainless steel piano-hinge. Equipped with a stainless steel cable door-swing limiter and two tumbler locks keyed like
other Bobrick washroom accessories.
Paper Towel Dispenser — 18-8 S, type-304, 0.8mm (22-gauge) stainless steel. Rounded towel tray has hemmed opening to dispense paper
towel without tearing. Capacity: 450 C-fold, 600 multifold, or 850 singlefold paper towels.
Waste Container — Leak-proof rigid molded plastic. Removable for servicing. Capacity: 12.5 liters (3.3 gal.).
Air Deflector — 18-8 S, type-304, .46mm (22-gauge) stainless steel.
continued . . .
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 4/09 Intl. Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2009 by Bobrick Washroom Equipment, Inc.
Dryer:
Cover — One-piece, 2.6mm (3/32") thick, fire-retardant molded, Bobrick grey color #889. VDE approved. Universal operating symbols on
front of cover. Cover is secured to mounting base with three flat-head stainless screws.
Mounting Base and Fan Housing — 2.0mm (5/64") thick, fire-retardant molded plastic with high-gloss grey finish. VDE approved. Airinlet grille fits into bottom of mounting base. Air-outlet grille is secured between fan housing and mounting base.
Motor — 220 - 240 AC, 90 W, 50/60 Hz, 3300 rpm. Brushless, external rotor motor. Sealed ball bearings at both ends of drive shaft;
maintenance free. Equipped with an automatic thermal-overload switch.
Fan — Dynamically balanced, 133mm (5-15/64") diameter, centrifugal fan with multiple metallic vanes. Directs air flow from heating
element at 90 cfm, mixes air to provide uniform temperature.
Heating Element — Coiled nickel-chrome heating element is protected by an automatic thermal-overload switch. Heating element,
which is located on inlet side of fan, heats air without hot spots — inaccessible to vandals.
Electronic Control — Infrared sensor automatically turns dr yer on when hands are held under air-outlet opening and across path of
sensor. Remove hands from path of sensor and dryer stops. Electronic sensor has automatic shutoff approximately two minutes after
dryer turns on if inanimate object, such as tape or chewing gun, is placed across sensor lens. After inanimate object is removed, electronic
sensor automatically resets itself and dryer operates normally.
OPERATION:
Paper towel dispenser is adjustable to dispense C-fold, multifold, or singlefold paper towels without use of additional adapters or towel trays. To
service waste receptacle, unlock door with key provided and remove waste container. Cable door-swing limiter prevents damage to washroom
accessories and walls.
Dryer has no-touch operation. Electronic sensor automatically turns dryer on when hands are held under air-outlet opening and across path of
sensor. Remove hands from path of sensor and dryer stops. Dryer will not stop by itself before user is satisfied hands are dry. Dryer operates
only when actually drying hands, which saves energy and operating costs. Electronic sensor will automatically shut dryer of f two minutes after
dryer turns on if inanimate object is placed across sensor lens. After inanimate object is removed, electronic sensor automatically resets itself
and dryer operates normally.
1-Year Limited Warranty — This war ranty is limited to the repair or exchange of defective dryer parts at the option of Bobrick. See
Installation Instruction Sheet, Form No. 710E-69, for full details.
INSTALLATION:
Provide framed rough wall opening 352mm wide x 1385mm high (13-7/8'' x 54-9/16''). Minimum recessed depth required from finish face of
wall is 145mm (5-3/4''). Allow clearance for construction features that may protr ude into rough wall opening from opposite wall. Coordinate
with mechanical engineer to avoid pipes, vents, and conduits. If unit projects above top of wainscot, provide aluminum channel or other filler to
eliminate gap between flange and finish face of wall. Mount unit in wall opening with shims between framing and cabinet at all points indicated
by an S, then secure unit with screws furnished by manufacturer.
Dryer Wiring Instructions:
Connect the 230-volt wires as follows. The neutral wire should be connected to the terminal marked N. The live wire should be connected to the
terminal marked L.
Notes: Electronic sensor in dryer will pick up movement within 100mm (4") of air-outlet nozzle. Use caution when choosing location for dryer
in confined areas. Consider proximity to doorways and other traffic areas.
For installation instructions that include step-by-step installation procedures and details of electrical ser vice connections, see Form No. 710E-69,
which is packed with each shipment. This form is also available in advance upon request.
SPECIFICATION:
Recessed paper towel dispenser and waste receptacle shall be type-304 stainless steel with all-welded construction; exposed sur faces shall have
satin finish. Door shall be 1.2mm (18 gauge); have 14mm (9/16'') 90° return edges; be secured to cabinet with a concealed, full-length stainless
steel piano-hinge; and equipped with a stainless steel cable door-swing limiter and two tumbler locks keyed like other Bobrick washroom
accessories. Paper towel dispenser shall be capable of dispensing 450 C-fold, 600 multifold, or 850 singlefold paper towels. Waste receptacle
shall be furnished with a removable, leak-proof, rigid molded plastic waste-container with a capacity of 12.5 liters. (3.3 gal.). Air deflector shall
prevent dryer from blowing into waste container.
Hand dryer shall have a one-piece, fire-retardant molded, Bobrick grey color #889. Mounting base and fan housing shall be fire-retardant
molded plastic with high-gloss grey finish. Brushless motor shall be 90 watts, external rotor type with sealed ball bearings on ends of drive
shaft and equipped with an automatic thermal-overload switch. Centrifugal fan shall have multiple metallic vanes. Heating element shall be
located on inlet side of fan, shall heat without hot spots, be inaccessible to vandals, and protected by an automatic thermal-overload switch.
Electronic sensor shall automatically turn dr yer on when hands are held under air-outlet opening and across path of sensor. Dryer will turn off
automatically when hands are removed. Sensor shall automatically shut dryer off approximately two minutes after dr yer turns on if inanimate
object is placed across sensor lens. After inanimate object is removed, electronic sensor shall automatically reset itself and dr yer shall operate
normally. Unit shall be VDE approved, CE marked and CCC approved and protected by a limited 1-year warranty on all parts. Manufacturer's
service and parts manual shall be provided to the building owner/manager upon request.
Recessed Paper Towel Dispenser, Automatic Hand Dryer, And Waste Receptacle shall be Model B-38033 of Bobrick Washroom
Equipment, Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Company,
Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited, United
Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. B-38033 R/A,S/* Rev 4/09 Intl. Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2009 by Bobrick Washroom Equipment, Inc.
Loading...