BMR Suspension PHR010 User Manual

F-BODY PANHARD ROD INSTALLATION INSTRUCTIONS

Part #’s PHR001, PHR002, PHR003, PHR010, MPHR001, MPHR002, MPHR003 0

NON-ADJUSTABLE PANHARD RODSNON-ADJUSTABLE PANHARD RODS

1. Lift vehicle and support with jack stands.

2. Using a 18mm wrench, loosen the panhard rod bolts. Remove both bolts and pry the panhard rod out of

the mounts.

3. Position the BMR panhard rod into the mounts with the grease fittings pointing down. Insert the factory

bolts and torque to 80 ft/lbs.

4. With the suspension loaded, lube each grease fitting approximately 2-3 pumps.

5. Remove stands and lower vehicle.

ADJUSTABLE PANHARD RODS

1. Lift vehicle and support with jack stands.

2. Using a 18mm wrench, loosen the panhard rod bolts. Remove both bolts and pry the panhard rod out of

the mounts.

6. Adjust the BMR panhard rod to the length of the factory rod. This is a good starting point; the

adjustment will be done in a later step. Leave the jam nuts on the adjuster (or rod ends) loose.

3. Position the BMR panhard rod into the mounts with the

grease fittings (polyurethane equipped bushings only)
pointing down. If installing the poly/rod combo
panhard rod position the poly bushing to the body side
mount. Insert the factory bolts and torque to 80 ft/lbs.

4. If equipped with polyurethane bushings, lube each

grease fitting approximately 2-3 pumps.

5. For this step the vehicle must be at ride height. Measure

both wheel positions in the wheel wells as shown in the
image to the right. If they are already equal or within
1/8” tighten the jam nuts and disregard step 6 - you are
done. If the two measurements are not equal, proceed
to the next step.

6. With the jam nuts loose, adjust the Panhard rod

clockwise or counter-clockwise, depending on which
way you need the car to move. The car body will slide
left or right depending on which way you turn. Once
the rear is centered, tighten the jam nuts.

NOTE: To prevent the jam nuts from backing off, we

recommend using Loctite - Blue to secure them once the
adjustment is complete.

WWW.BMRSUSPENSION.COM

This product is an aftermarket accessory and is not designed by the vehicles manufacturer for use on this vehicle. As such, buyer

assumes all risk of any damage caused to the vehicle/person during the installation or use of this product.