BMR Suspension ELK010 User Manual

ELK010

INSTALLATION INSTRUCTIONS

2005-2014 Mustang

Tools required:

Jack and jack stands
Wrenches: 8mm, 14mm, 18mm, 19mm
Grease gun

Installation:

1. Lift front of vehicle and remove both

wheels/tires.

2. Use an 18mm wrench to remove the

nuts from the OE sway bar end links. If
the entire shaft of the end link spins,
use an 8mm wrench to hold the shaft
from the end while loosening the nut.

3. Remove the OE end link.

4. Using the OE end link as a guide,

adjust the BMR end link to the same
length. Once adjusted, tighten the jam
nuts on the BMR end link using a
19mm wrench.

5. Install the BMR end link onto the

vehicle. Tighten the nuts using a 19mm
wrench. If the entire shaft spins while
tightening, use a 14mm wrench to hold
the base of the shaft while tightening
the nut.

6. Duplicate steps 2-5 on the other side

then re-install the wheels/tires and
lower the vehicle.

WWW.BMRSUSPENSION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As

such, Buyer assumes all risk of any injury caused to the vehicle/person during installation or use of this product.