BMR Suspension DTB003 User Manual

DRIVESHAFT TUNNEL BRACE

DTB003 – 1967-1969 Camaro and Firebird Convertible

Tools required:

o 3/8” drive ratchet
o 9/16” socket
o 5/16” Allen wrench

Installation:

ft the vehicle high enough to gain access

1. Li
to the driveshaft tunnel area. Support with
jack stands.

2. Using the 9/16” socket, remove the six bolts
holding the OE tunnel brace in place.
Remove.

3. Position the BMR tunnel brace into place
and install the provided 3/8” Allen bolts with
washers.

4. Torque bolts to 40 ft/lbs.

5. Lower vehicle.

ABOVE IMAGE SHOWN WITH OPTIONAL 6 SPEED CROSSMEMBER.

WWW.BMRFABRICATION.COM

This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer

assumes all risk of any damage caused to the vehicle/person during installation or use of this product.